NEC NEAX2400 ICS, Руководство по программированию

Страница: 963 / 1089

NEAX2400 IPX Feature Programming Manual
Page 920
NDA-24297, Issue 1
H-11 House Phone - CCIS
H-11 House Phone - CCIS
General Description
This feature allows selected stations to call an Attendant Console through the CCIS network, simply by going off-
hook.
Operating Procedure
To call the Attendant
1. The HOUSE PHONE - CCIS user lifts the handset.
2. The Attendant is automatically called.
Service Conditions
1. Attendant Console indications will appear as follows:
a.) ATND lamp flashes.
b.) Console buzzer sounds.
2. HOUSE PHONEs may or may not be equipped with dials.
3. HOUSE PHONE - CCIS assignments are programmed into system data via the MAINTENANCE
ADMINISTRATION TERMINAL (MAT) [M-18].
4. There is no limit to the number of HOUSE PHONES - CCIS permitted in the network.
5. SPEED CALLING-SYSTEM [S-3] is used for HOUSE PHONE - CCIS calling if the Attendant is in
another office.
Interactions
1. The AHLS command is not needed if the House Phone (Hotline) is in the same node as the Attendant
Console. When a station is programmed as TEC: 14, HOTLINE, it will automatically be connected to the
Attendant Console.
2. If the House Phone is to be used for outgoing calls via the Attendant Console (ARSC Command RRI 2),
assign a Route Restriction Class that will allow these connections. The same consideration should be made
for incoming calls via the Attendant Console (RRI 0).
Programming
STEP 1: ASDT - Assign the station as a TEC = 14 for Hotline.
If the Attendant Console is in another node:
STEP 2: ASPD
- Assign the tenant number,
Abbreviated Digit Code (ADC) and Digit Code (DC).
STEP 3: AHLS
- Assign the station number of the House Phone using the following parameters:
HOT TN:Hotline Tenant
STN:
Hotline Station number
TYP: 2
ADC: Abbreviated Digit Code