NEC NEAX2400 ICS, Руководство по программированию

Страница: 1075 / 1089

NEAX2400 IPX Feature Programming Manual
Page 1032
NDA-24297, Issue 1
T-26 Toll Restriction - 3/6-Digit - CCIS
Programming (cont’d)
See DAY/NIGHT CLASS OF SERVICE [D-15] .
SYS2, Index 1, bit 3. Does TOLL RESTRICTION apply to SPEED CALLING - STATION? 0/1: Yes/
No.
SYS2, Index 1, bits 4 & 5. If TOLL DENIAL is required assign these bits as data “00”. If TOLL
DIVERSION is required assign these bits as “01”.
SYS2, Index 1, bit 7. Does TOLL RESTRICTION apply to SPEED CALLING - SYSTEM? 0/1: Yes/
No.
STEP 2: ARSC
- Assign Route Restriction Classes. When assigned to stations these classes will determine
whether or not a station will be allowed access to a specific route or specific dialing sequence. Assign
the following:
DAY/NIGHT:Day/Night Mode
D:
Day Mode
N: Night Mode
TN: Tenant Number
RT: Route Number
RSC: Route Restriction Class
RRI: Route Restriction Index
0: IC Restriction via ATTENDANT CONSOLE [A-3] (DDD, etc.)
1: IC Restriction Direct Connection (DID, etc.)
2: OG Restriction via ATTENDANT CONSOLE [A-3]
3: OG Restriction Direct Connection (DDD, etc.)
RES: Restriction Data
0: Connection is Restricted
1: Connection is Allowed
2: Connection is Toll Restricted
STEP 3: AMND - This command is used to tell the system the total number of digits to expect based upon the
first few DIGITS DIALED. 9 plus a local call will equal 8 digits, 9 plus 1 plus an Area Code call will
equal 12 digits. Assign the DIALED DIGITS information and the corresponding MAXIMUM
NECESSARY DIGITS (MND) data. Flag this data as a Toll call, (data 1), or a local call, (data 0).
Note: The digits underlined are to be listed in the DC parameter. Overseas or Operator assisted calls should be
listed with an MND = 24. Special dialing sequences such as 911 with an MND = 4 should also be listed.
N = 2 - 9, P = 0 or 1, X = 0 - 9
STEP 4: ATDP - This command is used along with AARP. This command designates the digit codes that will
be allowed, denied, or toll restricted. These codes are designated by Route Restriction Class. The
Number of Necessary Digit data is used to specify where a 3 or 6-digit translation should begin. The
digits to be examined for 3- or 6-digit translation are listed in AARP. Assign the following:
DAY/NIGHT:Day/Night Mode
D: Day Mode
N: Night Mode
TDM/OG:Tandem Connection/Outgoing Connection
T: Tandem Connection
O: Outgoing Connection
ICRT: Incoming Route Number (Tandem Connection Only)
RSC: Restriction Class (0-15)