NEC NEAX2400 ICS, Руководство по программированию

Страница: 228 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 185
Consultation Hold - All Calls - D
term
C-17D
Interactions (cont’d)
5. Features that cannot be activated while a user has a party in CONSULTATION HOLD-ALL CALLS are:
EXECUTIVE RIGHT-OF-WAY [E-1]
TRUNK ANSWER FROM ANY STATION [T-8]
CALL BACK, Activate or Cancel [C-1]
CALL PICKUP-DIRECT [C-30]
CALL FORWARDING, Activate or Cancel [C-2, 3, 5]
OUTGOING TRUNK QUEUING, Cancel [O-2]
SPEED CALLING-INDIVIDUAL, Entry [S-21]
MESSAGE REMINDER [M-19D]
6. All other features may be activated as long as the user’s line CLASS OF SERVICE-INDIVIDUAL [C-15]
allows that feature.
7. Upon establishing a CONSULTATION HOLD-ALL CALLS connection and dialing a third party, if the
user receives busy or reorder tone instead of ringback tone, the user flashes once to disconnect the tone
and reconnect the second party.
8. Upon establishing a CONSULTATION HOLD-ALL CALLS connection and dialing a
MISCELLANEOUS TRUNK ACCESS [M-2] code, if no dial tone is given (after the trunk is seized), or
if a mistake is made in dialing, or if intercept announcement or a permanent tone is given, the user must
go on-hook and wait for ringback tone.
9. A user, who established CONSULTATION HOLD-ALL CALLS, is reconnected to the party in soft hold
when the third party disconnects.
10. When using CALL TRANSFER-ALL CALLS [C-11] from a station (second party) to another station or
trunk (third party), the control station can transfer the call during ringing (blind transfer). When the control
station goes on-hook, the station in soft hold is connected to the third party’s connection and hears
ringback tone. A variable timer is set when the controlling station goes on-hook. If the timer times out
before the third party answers, the control station will receive ringback tone.
11. Reorder tone is returned to the station using CONSULTATION HOLD-ALL CALLS when the following
actions occur:
• The user attempts to place an off-net call using MISCELLANEOUS TRUNK ACCESS [M-2] on a
restricted route.
• The user dials the number of an unassigned station or station residing in an inaccessible tenant via
Tenant Service.
• The user dials vacant or invalid first digit (no assignment in the ANPD command either for level or
connection status).
• The TRANSFER key or FLASH BUTTON-D
term
[F-3D] is used instead of momentarily pressing the
switch hook. A FLASH BUTTON-D
term
[F-3D] is required for a Connection Index of B, Busy.
Programming
ASYD
- System Data 1, Index 156. Trunk Soft Hold Timer A, used with second dial tone trunks.
Assign data 00H for 30 seconds. (Data 31H may be used for a value of two seconds if CALL
TRANSFER-ALL CALLS [C-11] is to be used immediately after connecting to the trunk.) This is the
time between trunk connection and when switch hook flash is allowed on a non-senderized trunk
connection.