NEC NEAX2400 ICS, Руководство по программированию

Страница: 575 / 1089

NEAX2400 IPX Feature Programming Manual
Page 532
NDA-24297, Issue 1
M-84 MF Signaling - DID
M-84 MF Signaling - DID
General Description
In the Associated Channel Interoffice Signaling system, this feature allows use of selective codes of Multifrequency
(MF) signals.
MF - (ANSI) codes: A total of 15 codes are available by combining two out of six frequencies.
(ANSI)
Operating Procedure
No manual operation is required.
Service Conditions
1. When using MF signaling system, Least Cost Routing (LCR) or Register Sender LCR (LCRS) must be
assigned.
2. Even when LCRS is assigned, digit outpulsing to the distant office is not started until all digits have been
received when the signaling is MF. If there is DP or PB lines among alternate routes, an outgoing call may
be originated by seizing a DP or PB line, even when the route advance sequence for that line is lower than
MF lines. When the route advance sequence of MF to DP or PB is predetermined, LCR must be assigned
in the numbering plan.
3. Unless otherwise specified, MP starting at termination of an incoming call will be activated upon receiving
an ST signal.
CODE
CCITT/
BELL
0
(700HZ)
1
(900HZ)
2
(1100HZ)
4
(1300HZ)
7
(1500HZ)
K
(1700HZ)
1 1 X X
2 2 X X
3 3 X X
4 4 X X
5 5 X X
6 6 X X
7 7 X X
8 8 X X
9 9 X X
10 0 X X
11
C
11
X X
12
C
12
X X
13
KP
1
X X
14
KP
2
X X
15 ST X X