NEC NEAX2400 ICS, Руководство по программированию

Страница: 422 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 379
Hotline H-1
Interactions (cont’d)
2. CONSULTATION HOLD [C-17]: The HOTLINE station may put the destination station on
CONSULTATION HOLD [C-17]. In this state, the HOTLINE station may make an outgoing call, and is
therefore affected by CLASS OF SERVICE-INDIVIDUAL [C-15].
3. CALL WAITING-ORIGINATING [C-31]: A HOTLINE will not be allowed to camp-on to a busy
destination station.
4. If the connecting station is also a HOTLINE station, then the reverse connection must also be
programmed.
Programming
STEP 1: ASDT - Assign the station as a TEC = 14 for HOTLINE.
STEP 2: AHLS - Assign the station number programmed above for the following parameters:
HOT TN: HOTLINE Tenant
STN: HOTLINE Station
CON TN: Connecting Station’s Tenant
CON STN: Connecting Station Number
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
AHLSN - This data must be assigned to the NCN.
UGN: User Group Number
TELN: Telephone Number of the calling party
TYPE: 1 (The called party is a station)
CON UGN: User Group Number of the called party
CON TELN: Telephone Number of the called party
Note:
The current data should also be set in addition the above-mentioned command. The ASDT command must
be set to the node accommodating the calling party.