NEC NEAX2400 ICS, Руководство по программированию

Страница: 633 / 1089

NEAX2400 IPX Feature Programming Manual
Page 590
NDA-24297, Issue 1
P-10 Paging Transfer
P-10 Paging Transfer
General Description
This feature allows a user to transfer a paged call to a party that has been placed on hold.
Operating Procedure
While a user is engaged in a call
1. Switch hook flash or press TRANSFER key (on D
term
phone); receive special dial tone.
2. Dial the Paging Access Code; receive continuous ringback tone for approximately one second.
3. Page the desired party.
There are three paging options
1. NON-DELAY SYSTEM: The party paged is immediately connected to the paging station when the paged
party dials the Paging Answer Access Code.
2. DELAY SYSTEM: The paging user replaces the handset after the page; the paged party dials the Paging
Answer access code. The paging station rings, and the paged station receives ringback tone. After the
paging user lifts the handset, the paging and paged stations are connected.
3. PAGING TRANSFER SUPERVISION: The paging user replaces the handset after the page. By dialing
the Paging Answer access code, the paged party is directly connected to the party on hold.
For Non-Delay and Delay systems
1. When a paging station replaces the handset after talking with the paged party, the held party is directly
connected to the paged party.
Service Conditions
1. PAGING TRANSFER service can be selected according to system data assignment:
a.) Non-Delay system
b.) Delay and Non-Delay system
c.) PAGING TRANSFER Supervision
2. Paging trunks can be provided for a maximum of six routes.
3. When a paging route has been accessed and is not answered within a predetermined time, the paging
activation is automatically cleared.
4. Both the COT card and the TLT card can be used as the paging trunk.
5. Loop signaling is the recommended signaling type.
6. When the Attendant Console activates the service, the conditions are as follows:
a.) An Attendant Console user can connect the paged party with the calling party the same way as
PAGING TRANSFER SUPERVISION only (see Operating Procedure).
b.) If the paged party answers the page before the Attendant Console releases the loop, the Attendant
Console is called from the paged party as an operator call. In this case, the Attendant Console can
connect the paged party with the held party (calling party) in the procedure below:
•
Press the CANCEL key to release the loop to be used for the page.
• Answer the operator call and press the HOLD key to hold the loop.
• Press the loop key holding the calling party to be back to the original connection and perform
the normal operation for Attendant Console Loop-to-Loop Connection (see MEET-ME
PAGING
[M-1] for details) to connect the two parties.