NEC NEAX2400 ICS, Руководство по программированию

Страница: 142 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 99
Brokerage Hotline - Outside B-12
Programming (cont’d)
2: Multi-line Key
KD: 0
RG: Ringing Assignment per multi-line appearance
0: No ringing
1: Ringing in Day mode only
2: Ringing in Night mode only
3: Ringing in Day and Night mode
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
AHLSN - This data must be assigned to the NCN.
UGN: User Group Number of the calling party
TELN: Telephone Number of the calling party
TYPE: 2 (the called party is an outside line)
3 (the called party is a trunk)
CON UGN: User Group Number of the called party (for TYPE=2)
CON ADC: Abbreviated digits code assigned by the ASPD command (for TYPE=2)
CON LRN: Logical Route Number of the called party (for TYPE=3)
CON TK: Trunk Number of the called party (for TYPE=3)
Note:
The current data should also be set in addition to the command above.
The command to be set to the node accommodating the calling party: ASDT/AKYD/ASPD
If Hotline TEC=14, the ASFC command data must be assigned at all the nodes to be set Brokerage-Hotline
service: SFI=36 (Brokerage Hotline), RES=1 (allowed). When assigning Virtual Hotline, set the ASFC
command data to TEC=18.
If Hotline is Virtual TEC=18, assign SFI=36. If Hotline is a TEC=14, do not assign SFI=36.