NEC NEAX2400 ICS, Руководство по программированию

Страница: 764 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 721
Split Call Forwarding S-99
Programming (cont’d)
SN=1, FKY=2: Call Forwarding - All Calls (FDA)
SN=1, FKY=22: Call Forwarding - Don’t Answer (FDN)
SN=1, FKY=55: Call Forwarding - One - Touch Changeover (PAGE)
This command is used for assigning a function to each soft key.
STEP 6: ASFC - Allows Call Forwarding-All Calls (SFI = 7), Call Forwarding-Busy Line (SFI = 9), or Call
Forwarding-Don’t Answer (SFI = 8) to the SFC of the Station.
STEP 7: ARTD
- Assign route data to the route of the trunks which validates Call Forwarding - All Calls, Call
Forwarding - Busy Line or Call Forwarding - Don’t Answer for an incoming call from an outside
party. CDN 68:SCF = 1)
STEP 8: ACFS
- This feature can be set by this command.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
STEP 1: ARTDN - Assign route data to the route of the trunks which validates Call Forwarding - All Calls, Call
Forwarding - Busy Line or Call Forwarding - Don’t Answer for an incoming call from an outside
party. CDN 68:SCF = 1)
Note:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.