NEC NEAX2400 ICS, Руководство по программированию

Страница: 207 / 1089

NEAX2400 IPX Feature Programming Manual
Page 164
NDA-24297, Issue 1
C-11 Call Transfer - All Calls
Programming
STEP 1: ASYD - SYS2, Index 0, bit 0 = 1 (Allow the restriction for Call Back service)
SYS2, Index 5, bit 2. Camp-on by Station is set automatically after the operating station is released
from the connection after encountering the busy target station.
0 = No (Recall to the mediate station)
1 = Yes (Camp On service is set)
SYS2, Index 10, bit 7. Number of time(s) that the warning tone (Call Waiting Tone) is sent to the
target station.
0/1 = Once/At Intervals
Note: When “1” is assigned, the interval of this tone is assigned in SYS1, Index 152.
SYS 1, Index 248, bit 6. When the destination station has been set Call Forwarding - Don’t Answer.
0/1 = Recall to the station/Call Forwarding - Don’t Answer is activated
STEP 2: ANPD - Assign the first number level for the feature access code.
STEP 3: ASPA
- Assign the feature access code.
CI = H, SRV = SSC, SID = 3 (Call Back)
STEP 4: ASFC
- Assign the service feature class of Camp-on by Station.
SFI = 174 (Camp-on by Station) RES = 1 (Allowed)
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
STEP 1: ARSCN
- The station receiving the call must be assigned a Route Restriction Class (RSC) that will
allow the station to be connected to the trunk, if a trunk is involved.
Note: When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.