NEC NEAX2400 ICS, Руководство по программированию

Страница: 798 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 755
Toll Restriction - 3/6-Digit T-7
Programming (cont’d)
Example 6 - Trunk-to-Trunk Connection
Allow all Local Calls
ATDP Command-
TDM/OG: T (Tandem Connection)
ICRT: Route 2 OGRT: 1
DC: 92 TDI: 1 (Connection is Allowed)
Repeat these same assignments for Digit Codes “93” through “99” to allow all local office codes.
Notice that assignments for digit codes “90” and “91”, which cover operator calls and all 1 + Area
Code calls, are not assigned. Digit Codes not assigned are automatically restricted.
Example 7 - Trunk-to-Trunk Connection
Allow Limited Area Codes
ATDP Command-
TDM/OG: T (Tandem Connection)
ICRT:
Route 2 OGRT: 1
DC: 92 TDI: 1 (Connection is Allowed)
Repeat these same assignments for Digit Codes “93” through “99” to allow all local office codes.
To allow Area Codes 718, 212, 201, and 914 repeat the ATDP command for the following Digit
Codes:
DC: 91718 TDI: 1(Allow)
DC: 91212 TDI: 1(Allow)
DC: 91201 TDI: 1(Allow)
DC: 91914 TDI: 1(Allow)
This allows these specific Area Codes.
All the Area Codes which are not assigned are automatically restricted.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note 1
STEP 1: ARSCN
- Assign the route restriction class.
STEP 2: ATDPL/N
- Assign the digit codes to be allowed or denied access, or toll-restricted.
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
Note 2: For more detailed information, see the NEAX2400 IPX Fusion Network System Manual.