NEC NEAX2400 ICS, Руководство по программированию

Страница: 753 / 1089

NEAX2400 IPX Feature Programming Manual
Page 710
NDA-24297, Issue 1
S-61 Speed Calling Override - System
S-61 Speed Calling Override - System
General Description
This feature allows numbers programmed for SPEED CALLING to be available to stations on a system-wide basis,
determined by Service Feature Class (SFC). For example, SPEED CALLING-SYSTEM [S-3] numbers, available
to stations that are not restricted, can be made available to stations that are restricted.
Operating Procedure
To operate
1. Lift the handset (includes SPEAKER key operation on D
term
). Listen for dial tone.
2. Dial the SPEED CALLING-SYSTEM [S-3] access code (maximum three digits).
3. Dial the abbreviated code (maximum four digits).
4. If the station is allowed this call, the call is completed; if not, the station will hear a reorder tone.
To operate from a D
term
1. Press the REDIAL key; receive dial tone. The LCD displays:
2. Press the desired call code.
3. If the station is allowed this call, the call is completed; if not, the station will hear a reorder tone.
Service Conditions
1. This feature cannot be used on an outgoing call which uses OUTGOING TRUNK QUEUING [O-2].
2. This service can be used in combination with CONSECUTIVE SPEED CALLING - SYSTEM [C-62].
3. This feature cannot be used in MFC signaling.
4. This feature cannot be used if the calling station is holding another line.
5. This Attendant Console cannot use this feature.
6. SPEED CALLING-SYSTEM [S-3] must first be provided.
Interactions
1. SPEED CALLING-SYSTEM [S-3] must first be provided.
2. FORCED ACCOUNT CODES [F-7] and AUTHORIZATION CODES [A-20] cannot be programmed for
use via SPEED CALLING-SYSTEM [S-3].
3. Pauses are programmable from the MAT, using the “P” key. Pauses consume one digit of the 24 digits
available. A pause lasts for 2.8 seconds.
4. TOLL DIVERSION/TOLL DENIAL [T-6] and TOLL RESTRICTION 3/6 DIGIT [T-7] will not interact
with this feature if a station is allowed access to an ADC via Service Feature Class.
5. AUTHORIZATION CODES [A-20] are never required to complete a call.
LNR [*] / SPD [_ _]
(Time Display)