NEC NEAX2400 ICS, Руководство по программированию

Страница: 345 / 1089

NEAX2400 IPX Feature Programming Manual
Page 302
NDA-24297, Issue 1
D-87 Dial Intercom
Operating Procedure (cont’d)
PRIME LINE PICK UP-D
term
[P-13D]
The D
term
may be programmed to seize the incoming call on the AUTOMATIC, MANUAL, or DIAL INTERCOM
lines before the Prime Line. If two incoming calls terminate simultaneously to both the Prime Line and the DIAL
INTERCOM line, when the user goes off-hook, PRIME LINE PICKUP-D
term
[P-13D] will seize the DIAL
INTERCOM line before the Prime Line. If only the Prime Line is ringing when the user goes off-hook, then PRIME
LINE PICKUP D
term
[P-13D] will seize the Prime Line. The programmable options and ringing priority are
illustrated in the following table:
Service Conditions
1. Only D
term
s can be assigned as a member of a DIAL INTERCOM group.
2. All members of the same DIAL INTERCOM group must be assigned in the same Module Group.
3. Up to 32 stations may be assigned to one DIAL INTERCOM group. Each station in the DIAL
INTERCOM group can be assigned as an Automatic, a Manual and a DIAL INTERCOM member of three
different groups.
4. No more than one connection can be established at the same time in one DIAL INTERCOM group.
5. A three-party conference can be established in a DIAL INTERCOM group if Intercom Bridge service is
available. If a fourth party tries to activate Intercom Bridge service, the connection is denied.
6. The maximum number of DIAL INTERCOM groups in the PBX is 50 per Module Group.
7. It is possible to simultaneously assign one group of stations as an Automatic/Manual Intercom group, as
well as a DIAL INTERCOM group.
8. The distinctive ringing (three-burst ringing) sent from an incoming DIAL INTERCOM station takes
priority over the ringing of multi-line appearances.
9. Features normally available to multi-line appearances are not available to DIAL INTERCOM lines.
10. DIAL INTERCOM lines cannot be held by pressing the HOLD key.
11. When a station is moved from one DIAL INTERCOM group to another via system commands, the DICM
key on the associated D
term
must be deleted before the change is made.
12. Port traffic and station PEG COUNTS [P-7] reports will record the use of the DIAL INTERCOM feature
under “other.”
13. Dedicated D
term
feature keys cannot be used during a DIAL INTERCOM call. Only the SPEAKER key
for hands-free operation can be used.
14. If there are simultaneous incoming calls to the Prime Line, Automatic Intercom Line, the Manual Intercom
Line, and/or the DIAL INTERCOM line, the Prime Line will normally be selected when the station goes
off-hook. The selection order can be changed for each D
term
via office data assignment.
15. DIAL INTERCOM group numbers are either one or two digits and can be set for each DIAL INTERCOM
group:
1 digit: 0-9
2 digits: 00-63
RINGING
PRIORITY
PROGRAMMABLE OPTIONS
PRI0 PRI1 PRI2 PRI3 PRI4
1 Prime Line Dial Intercom Automatic Intercom Manual Intercom Automatic Intercom
2 -- Prime Line Prime Line Prime Line Manual Intercom
3 -- -- -- -- Prime Line