NEC NEAX2400 ICS, Руководство по программированию

Страница: 292 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 249
Call Block C-150
Service Conditions (cont’d)
29. When confirming the registered Restriction Number, the oldest number registered on MY LINE is
displayed for 5 seconds on the LCD. When the multiple Restriction Number is assigned, press CALL
BLOCK key to change the display to the later registered number, the displayed number is changed in order
as the key is pressed.
30. When deleting the Restriction Number with the access code from a D
term
, the oldest Restriction Number
is deleted.
31. When five Restriction Numbers are registered at a line, the assignment of the already registered number
is available.
32. System data decides the “*” key or the “#” key as the Restriction Number Delete key. When Delete key
is decided, the other one is used as Set key.
Note: The Set/Delete key is available for only 5 seconds (while the number is displayed).
33. When the proper ELC card is not used, the indication for the operation is not displayed at the middle line
of the LCD. In this case, Restriction Number is set or deleted by Set/Delete key (“*” or “#”).
34. When all calling numbers are deleted, the CALL BLOCK key goes off.
35. ACID applies only to inbound trunk calls with ANI.
36. ACID will not light a feature key if the telephone is equipped with one.
37. ACID will operate via the FCCS network for tandem trunk calls.
38. Feature keys and SIDAs will operate for physical and logical stations, as well as inbound trunk calls with
ANI. It will also light the feature keys for both.
39. The COT card for receiving the Caller ID information is shown below:
40. The LC card for notifying the Caller ID information is shown below.
CIRCUIT CARD NAME PROGRAM ISSUE
PA-8COTBJ
SW-317 8COTBJ PROG-A
—SP-1122 CALL-ID PROG-A
—SP-3190 8COTBJ PROG-A
CIRCUIT CARD NAME PROGRAM ISSUE
PA-16LCBY SP-3396 16-LCBX PROG-A