NEC NEAX2400 ICS, Руководство по программированию

Страница: 360 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 317
Direct Station Selection (DSS) Console D-149
Service Conditions (cont’d)
3. The 48th key and after can be used only as the feature keys, not as the line keys. (These keys do not have
the green lamps, therefore, I-used or I-hold cannot be indicated.)
4. Only 8-button and 16-button D
term
can be used when using the DSS console in the ADM mode.
5. The D
term
to be connected to the DSS console should be accommodated in the same circuit card as the
DSS consoles on the even-numbered port, using a number smaller than the one where the DSS console is
accommodated.
Programming
This section describes how to program office data associated with the DSS.
DSS/BLF
This section describes how to assign a DSS/BLF. For ease in understanding, the associated data
programming is explained using the example below:
Data Programming Procedure (DSS/BLF)
When assigning DSS/BLF data, perform the following procedure. Note that “X” indicates the value
should be tailored to the existing system.
TERMINAL LINE EQUIPMENT NUMBER (LEN) STATION NUMBER (STN)
DSS/BLF
Note
000100 200
000101 201
D
term
000107 400
LV
7
6
5
4
3
2
1
0
Note:
Two station numbers are required only for programming DSS keys. Accordingly, these numbers are
not used when operating the DSS/BLF.
00 05 04 03 02 01
54 59 58 57 56 55
48 53 52 51 50 49
42 47 46 45 44 43
36 41 40 39 38 37
30 35 34 33 32 31
24 29 28 27 26 25
18 23 22 21 20 19
12 17 16 15 14 13
06 11 10 09 08 07
1 2 3
4 5 6
7 8 9
0 #
D
term
(STN 400)
To D
term
(STN 400)
No terminal can be wired to this port
(STN 201) when a DSS/BLF is assigned
to “port 0”.
To DSS/BLF
DSS/BLF (STN 200)
ELC
n + 1
n