NEC NEAX2400 ICS, Руководство по программированию

Страница: 964 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 921
Hotline - CCIS H-12
H-12 Hotline - CCIS
General Description
This feature allows two stations at different nodes in the CCIS network to be associated with one another on an
automatic ringdown basis.
Operating Procedure
1. Station A lifts the handset.
2. Station B is rung.
3. Station B lifts the handset; the connection is established.
Service Conditions
1. If both phones in a HOTLINE - CCIS pair are equipped with dials, either one may transfer a HOTLINE -
CCIS call to another station in the CCIS network, using the CALL TRANSFER-ALL CALLS - CCIS [C-
50] feature.
2. There is no limit to the number of originating HOTLINE - CCIS stations.
3. HOTLINE - CCIS assignments are programmed into system data via the Maintenance Administration
Terminal (MAT).
4. HOTLINE - CCIS uses SPEED CALLING-SYSTEM [S-3] memory. Therefore, a total of 1000
HOTLINE - CCIS destinations, HOTLINE-OUTSIDE [H-9], and SPEED CALLING-SYSTEM codes are
available.
5. OUTGOING TRUNK QUEUING - CCIS [O-12] is not provided for a HOTLINE - CCIS call.
6. A HOTLINE - CCIS station can be assigned as a line/feature key on a D
term
. See TRUNK LINE
APPEARANCE [T-23] .
7. The MY-Line of a D
term
cannot be assigned as a HOTLINE - CCIS.
Interactions
1. The connecting station does not have to be a HOTLINE station. If the connecting station is busy, the
HOTLINE station will hear reorder tone, or CALL WAITING-ORIGINATING [C-31] will be
automatically set.
2. CALL BACK [C-1]: If the connecting station of a HOTLINE connection is busy, CALL BACK is
allowed.
3. CONSULTATION HOLD-ALL CALLS [C-58]: The HOTLINE station may put the destination station
on CONSULTATION HOLD-ALL CALLS. In this state, the HOTLINE station may make an outgoing
call and is therefore affected by CLASS OF SERVICE-INDIVIDUAL [C-15].
4. CALL WAITING-ORIGINATING [C-31]: A HOTLINE is allowed to camp-on to a busy destination
station. Assign SFI 5 (Call Waiting-Calling Side), SFI 6 (Call Waiting-Called Side) to SFC 0 and CDN
46:CW at the remote node.
5. If the connecting station is also a HOTLINE, then the reverse connection must also be programmed.