NEC NEAX2400 ICS, Руководство по программированию

Страница: 766 / 1089

NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 723
Slumber Time - Do Not Disturb S-106
Service Conditions (cont’d)
16. CALL BACK [C-1] and CALL WAITING-ORIGINATING [C-31] can be set from a Slumber Time
station.
17. Each of the following services is restricted to a Slumber Time station:
CALL WAITING-ORIGINATING [C-31]
CALL BACK [C-1]
EXECUTIVE RIGHT-OF-WAY [E-1]
18. Each of the following terminals can access to a Slumber Time station during a Slumber Time. (Slumber
Time Override Service):
• Attendant Console
• Station having the SFC that allows Slumber Time Override (ASFC SFI = 107)
• Trunk in the trunk route assigned to ARTD SLOV = 1
19. DAT card is used as the announcement machine.
20. To provide this service in the FCCS network, all the nodes in the network must be assigned the same group
number.
21. Errors of time data are about + 1 minute.
Programming
STEP 1: ARTD
- Assign the route class data route number of the announcement trunk. Note
STEP 2: ATRK
- Assign the trunk data of the announcement machine. Note
STEP 3: MBTK
- Cancel the make-busy of the announcement trunk assigned by ATRK. Note
STEP 4: AAED
- Assign the data of the announcement machine as shown below: Note
EQP = 36: Announcement machine for Slumber Time Group 1
37: Announcement machine for Slumber Time Group 2
38: Announcement machine for Slumber Time Group 3
39: Announcement machine for Slumber Time Group 4
40: Announcement machine for Slumber Time Group 5
41: Announcement machine for Slumber Time Group 6
42: Announcement machine for Slumber Time Group 7
C = [ x ]
R = [ x ]
A = [ x ]
M = 1: Multiple Connection
RT = [ x ] When using a 1-channel announcement machine by more than one Slumber
TK = [ x ] Time Group, assign the same data.
C = Connection time: Disconnected in 30 second/connected until caller releases the station (= 0/1)
R = RBT TRANSMISSION: RBT transmission/No RBT transmission (= 0/1)
A = Call is answered directly/call is extended to an answering device.
Note: The data is to be assigned only when announcement machine is designated as the transfer destination.
STEP 5: ASLU1
- Assign Slumber Time Group and Slumber Time Data.
Assignment of Slumber Time Group
TN =
[ x ] Tenant Number
STN = [ x ] Station Number
G = [ x ] Slumber Time Group Number (1-7)