NEC NEAX2400 ICS, Руководство по программированию

Страница: 439 / 1089

NEAX2400 IPX Feature Programming Manual
Page 396
NDA-24297, Issue 1
I-6 Individual Attendant Access
I-6 Individual Attendant Access
General Description
This feature permits a user to call a particular ATTENDANT CONSOLE [A-3] via an individual Attendant
identification number.
Operating Procedure
1. The user dials the individual Attendant identification number.
2. The directed Attendant gets INCOMING CALL IDENTIFICATION (ICI) [I-2] indication (“ATND”) and
can answer using the normal operating procedure.
Service Conditions
1. Attendant identification numbers (maximum 5 digits) must be programmed and published for each
Attendant Console.
2. The ASAT number should be the same number of digits as any other station number. ASAT assigns a
station number to each Attendant Console.
3. ATTENDANT NIGHT TRANSFER [A-19] feature cannot be activated for calls in this feature.
4. The individual attendant identification number cannot be used to assign the destination of Call Forwarding
service.
5. Only a Telephone Number can be assigned as the individual attendant identification number when this
feature is activated via FCCS.
Programming
STEP 1: ASAT
- Assign a station number to each Attendant Console. The Attendant Console number is the
trunk number assigned in the ATRK command, Route 901.
STEP 2: ATNR
- Allow tenant stations either access or denial to the tenant in which the Attendant Console is
located.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1: ALGNN
- This command must be assigned to the NCN. Assign the User Group Number and
Telephone Number for the individual attendant identification number.
STEP 2: ASATN
- This command must be assigned to the NCN. Assign User Group Number (UGN),
Telephone Number assigned by the ALGNN command for specifying the attendant console (ACC),
Fusion Point Code accommodating the designated attendant console (FPC), tenant number to which
the attendant console belongs (TN), and the trunk number assigned by the ATRK command for the
attendant console (ATN).
Note: Assign the ATNR command data to both the nodes accommodating the station and the attendant console.