NEC NEAX2400 ICS, Руководство по программированию

Страница: 657 / 1089

NEAX2400 IPX Feature Programming Manual
Page 614
NDA-24297, Issue 1
R-2 Remote Access to System
Programming (cont’d)
STEP 6: MBTK - Assign the Make Idle status to the REMOTE ACCESS TO SYSTEM trunks.
STEP 7: ACSI - Assign Route Number, Trunk Number, and Connection Service Index (CSI) = 5, REMOTE
ACCESS TO SYSTEM, Incoming DDD Ring down trunks are automatically connected as a Remote
Access trunk. They do not use ARAC access codes.
STEP 8: ARAC
- This command is used when a TIE Line or DID line will serve as a Remote Access to the
PBX line. A DID call will pulse into the system with digits that resemble a station number. That station
number is assigned as the REMOTE ACCESS TO SYSTEM access code.
STEP 9: ARRC
- Allow trunk-to-trunk connection between the Remote Access route and to those outgoing
routes this feature will access. Assign using ARI-D-RES, Direct Connection.
STEP 10: ACFR
- Allow the types of incoming calls listed in the Call Class Index (CCI) LDN, CCSA, that will
be connected to Remote Access. REMOTE ACCESS TO SYSTEM is Transfer Service Feature Index
(TSFI) number 7.
STEP 11: ASTD - Assign the state translation data: STM=4, SYS=0, ST=1 (Remote Access to PBX In Service).
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
STEP 1: ARTDN
- Assign the Remote Access route as shown below:
C.O.TRUNK:
RT: 1
3-ISGS
:1 4-INSG :2/3 5-TF :2 6-TCL :1 7-L/T :1
8-RLP :2 10-SMDR :0/1 38-FA :1
DIRECT INWARD DIAL (WINK START):
RT: 1
3-ISGS
:7 4-INSG :2/3 5-TF :2 6-TCL :1/4 7-L/T :1
8-RLP :2 10-SMDR :0/1 15-LSG :8 38-FA :1
STEP 2: ARRCN
- Allow trunk-to-trunk connection between the Remote Access route and to those outgoing
routes this feature will access. Assign using ARI-D-RES, Direct Connection.
Note:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.