Suzuki 2006 SX4, Service Manual

Page: 80 / 1478

1A-36 Engine General Information and Diagnosis:
)
*P0335
Crankshaft Position
(CKP) Sensor “A” Circuit CKP sensor signal is not detected for 2 sec. even though
starter is operated. 1 driving
cycle
1 driving
cycle
)
*P0340
Camshaft Position (CMP)
Sensor “A” Circuit
If either of the following condition is fulfilled:
• CMP sensor pulse is lower than 20 pulses per
crankshaft 8 revolutions.
• CMP sensor pulse is higher than 28 pulses per
crankshaft 8 revolutions.
• CMP sensor pulse is lower than 20 pulses per
crankshaft 8 revolutions from engine start.
1 driving
cycle
1 driving
cycle
)
* U P0420
Catalyst System
Efficiency below
Threshold
Ratio of integrated value of HO2S output variation per
integrated value of A/F sensor output variation is more
than specification while vehicle is running after warmed
up.
2 driving
cycles
2 driving
cycles
)
*P0443
Evaporative Emission
System Purge Control
Valve Circuit
• Monitor signal of EVAP canister purge valve is not
varied for 5 sec. even though EVAP canister purge
valve control duty is between 10% and 90%.
• Monitor signal of EVAP canister purge valve is lower
than specified voltage for 5 sec. even though EVAP
canister purge valve control duty is 0%.
2 driving
cycles
2 driving
cycles
)
P0462
Fuel Level Sensor “A”
Circuit Low Circuit voltage of fuel level sensor is lower than 0.11 V for
5 sec. with engine running. 1 driving
cycle
Not
applicable
)
P0463
Fuel Level Sensor “A”
Circuit High Circuit voltage of fuel level sensor is lower than 4.77 V for
more than 5 sec. with engine running. 1 driving
cycle
Not
applicable
)
*P0480
Fan 1 Control Circuit
Monitor signal of radiator cooling fan relay No.1 is lower
than specified voltage for 5 sec. even though radiator
cooling fan relay No.1 is OFF.
1 driving
cycle
1 driving
cycle
)
*P0481
Fan 2 Control Circuit
Monitor signal of A/C condenser cooling fan relay is lower
than specified voltage for 5 sec. even though A/C switch
is ON and A/C condenser fan is OFF.
2 driving
cycles
2 driving
cycles
)
*P0500
Vehicle Speed Sensor “A”
(VSS)
• Vehicle speed signal is lower than 2 km/h (1.2 mph) for
4 sec. while fuel shuts off at deceleration below 3,600
rpm.
• Vehicle speed signal is lower than 2 km/h (1.2 mph) for
4 sec. even though engine is running at D-Range with
more than 3,600 rpm (A/T model).
2 driving
cycles
2 driving
cycles
)
P0504
Brake Switch “A”/”B”
Correlation
If either of the following condition is fulfilled:
• Brake pedal switch signal (ON) and brake light switch
signal (ON) are detected at a time.
• Brake pedal switch signal (OFF) and brake light switch
signal (OFF) are detected at a time.
1 driving
cycle
Not
applicable
)
P0532
A/C Refrigerant Pressure
Sensor “A” Circuit Low Output voltage of A/C refrigerant pressure sensor is lower
than 0.2 V for 5 sec. 1 driving
cycle
Not
applicable
)
P0533
A/C Refrigerant Pressure
Sensor “A” Circuit High Output voltage of A/C refrigerant pressure sensor is
higher than 4.93 V for 5 sec. 1 driving
cycle
Not
applicable
)
*P0601
Internal Control Module
Memory Check Sum Error
Data write error or check sum error.
1 driving
cycle
1 driving
cycle
)
P0602
Control Module
Programming Error
Data programming error
1 driving
cycle
Not
applicable
)
*P0607
Control Module
Performance
ECM internal processor error.
1 driving
cycle
1 driving
cycle
)
* U P0616
Starter Relay Circuit Low
Starter switch signal is not detected even though engine
speed is 500 rpm or more. 2 driving
cycles
2 driving
cycles
)
*P0617
Starter Relay Circuit High Starter switch signal is detected for 180 sec.
2 driving
cycles
2 driving
cycles
DTC No. Detecting item
Detecting condition
(DTC will set when detecting:)
DTC MIL