Suzuki 2006 SX4, Service Manual

Page: 718 / 1478

5A-130 Automatic Transmission/Transaxle:
Reassembly
1) Apply A/T fluid to new O-ring and install O-ring (1) to
forward clutch accumulator piston (2).
2) Press forward clutch accumulator piston (2) into
transaxle rear cover.
NOTE
Do not twist or deviate O-rings during
installation.
3) Install forward clutch accumulator spring (3) and
forward clutch accumulator cover (4) with 2 bolts.
Tightening torque
Forward clutch accumulator bolts (a): 10 N·m (
1.0 kgf-m, 7.5 lb-ft)
4) Apply A/T fluid to new oil seal rings and install oil
seal rings (1) to transaxle rear cover (2).
NOTE
• Do not spread oil seal ring ends
excessively.
• Make sure that opening ends of oil seal
rings are not lined up so as to prevent fluid
leakage.
Transaxle Rear Cover Inspection
S6RW0C5106069
Measure free length forward clutch accumulator spring.
If necessary, replace with a new one.
Forward clutch accumulator spring free length
Standard: 66.64 mm (2.624 in.)
Automatic Transaxle Unit Assembly
S6RW0C5106070
1) Apply lithium grease to new manual shift shaft oil
seal lip.
: Grease 99000–25030 (SUZUKI Super Grease C)
2) Press-fit new manual shift shaft oil seal (1) to
transaxle case, using special tool.
Special tool
(A): 09943–88211
3) Apply A/T fluid to new oil seal rings (1) and install oil
seal rings (1) to transaxle case.
NOTE
Do not spread oil seal ring ends excessively.
1
2
3
4
(a)
I4RH01510193-01
1
2
I4RH01510194-01
I4RH01510158-01
1
(A)
I4RH01510195-01
1
I4RH01510196-01