Suzuki 2006 SX4, Service Manual

Page: 404 / 1478

2B-19 Front Suspension:
6) Tighten front suspension frame bolts to specified
torque.
Tightening torque
Front suspension frame mounting bolt: 150 N·m
(15.0 kgf-m, 108.5 lb-ft)
7) Remove mission jack from front suspension frame.
8) Install engine rear mounting and tighten mounting
member bolts referring to “Engine Mountings
Components in Section 1D”.
9) Remove chain hoist from engine assembly.
10) Connect torque sensor connector and P/S motor
connector to steering gear case referring to “Steering
Gear Case Assembly Removal and Installation in
Section 6C”.
11) Install suspension control arms referring to
“Suspension Control Arm / Bushing Removal and
Installation”.
12) Install stabilizer joint (1) and tighten nut to specified
torque.
When tightening nut, hold stud with hexagon wrench
(2).
Tightening torque
Stabilizer joint nut (a): 50 N·m (5.0 kgf-m, 36.5
lb-ft)
13) Connect tie-rod end to steering knuckle referring to
“Tie-Rod End Removal and Installation in Section
6C”.
14) Install exhaust No.1, No.2 and center pipe referring
to “Exhaust System Components in Section 1K”.
15) Install wheel and tighten nut to specified torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
16) Install air cleaner assembly referring to “Air Cleaner
Assembly Removal and Installation in Section 1D”.
17) Install hood referring to “Hood Removal and
Installation in Section 9J”.
18) Lower hoist and vehicle in unloaded condition,
tighten suspension control arm bolts to specified
torque.
Tightening torque
Suspension control arm bolt: 95 N·m (9.5 kgf-m,
69.0 lb-ft)
19) Connect negative (–) cable at battery.
20) Confirm front wheel alignment referring to “Front
Wheel Alignment Inspection and Adjustment”.
Front Suspension Frame, Stabilizer Bar and/or
Bushing Removal and Installation (4WD Model)
S6RW0C2206016
WARNING
!
When supporting and installing front
suspension frame, be sure to apply some
supporting equipment (such as mission jack)
at well-balanced position in the center
section of front suspension frame so as to
prevent from its drop. Otherwise drop and
injure.
CAUTION
!
When removing and installing suspension
control arm, be careful not to damage dust
boots of suspension control arm joint by
drive shaft dust cover and brake dust cover.
Removal
1) Remove front suspension frame, steering gear case
assembly and transfer all together referring to
“Transfer Dismounting and Remounting in Section
3C”.
2) Remove steering gear case assembly from front
suspension frame.
3) Remove stabilizer bar (1) with bushing from front
suspension frame (2).
Installation
Install front suspension frame by reversing removal
procedure, noting the following instruction.
• Tighten all fasters to specified torque referring to
“Front Suspension Construction”.
1
2
(a)
I5RW0A220033-01
1
2
I7RW01220016-01