Suzuki 2006 SX4, Service Manual

Page: 811 / 1478

Power Assisted Steering System: 6C-9
DTC Clearance
S6RW0C6304004
1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located on underside of instrument panel
at driver’s seat side.
Special tool
(A): SUZUKI scan tool
3) Turn ignition switch to ON position.
4) Erase DTC according to the instructions displayed
on SUZUKI scan tool. For further details, refer to
operator’s manual for SUZUKI scan tool.
5) After completing the clearance, turn ignition switch to
OFF position and disconnect SUZUKI scan tool from
DLC.
DTC Table
S6RW0C6304005
CAUTION
!
Be sure to perform the “EPS System Check” before starting troubleshooting corresponding to each
DTC.
(A)
1
I5RW0A630004-01
DTC
No.
Detecting item
Detecting condition
(DTC will set when detecting)
Trouble area DTC
“EPS”
warning
light
No
CODES
Normal — — — —
)
C1111
Steering torque sensor
(Main) circuit voltage
Circuit voltage of sensor main is
more than 4.5 V or less than 0.5
V
• Torque sensor signal
circuit
• Torque sensor
• P/S control module
1 driving
cycle
1 driving
cycle
)
C1113
Steering torque sensor
(Main and Sub) circuit
correlation
Difference between steering
torque calucurated based on
sensor main signal and steering
torque calucurated based on
sensor sub signal is more than
4.9 N
⋅
m
or
Difference between
instantaneous value and average
value of steering torque
calculated based on sensor main
signal and steering torque
calculated based on sensor sub
signal is more than 2.94 N
⋅
m
1 driving
cycle
1 driving
cycle
)
C1115
Steering torque sensor
(Sub) circuit voltage
Circuit voltage of sensor sub
signal is more than 4.5 V or less
than 0.5 V
1 driving
cycle
1 driving
cycle
)
C1116
Steering torque sensor
power supply circuit Circuit voltage of torque sensor 9
V power supply is less than 7 V
• Torque sensor 9 V
power supply circuit
• Torque sensor
• P/S control module
1 driving
cycle
1 driving
cycle