Suzuki 2006 SX4, Service Manual

Page: 538 / 1478

4C-3 Rear Brakes:
8) Install rear wheel referring to “Wheel (with Tire)
Removal and Installation in Section 2D”.
9) After completion of installation, check for brake
effectiveness.
Rear Disc Brake Caliper Removal and
Installation
S6RW0C4306003
CAUTION
!
Do not allow brake fluid to get on painted
surfaces. Painted surfaces will be damaged
by brake fluid, flush it with water immediately
if any fluid is spilled.
Removal
1) Hoist vehicle and remove rear wheel.
2) Release parking brake lever.
3) Remove clip (1).
4) Loosen brake pipe flare nut (1) using by flare nut
wrench.
Then remove clip (2).
5) Remove flexible hose joint bolt (3), and disconnect
brake flexible hose (4) from brake caliper.
6) Remove caliper pin bolts.
7) Remove caliper from brake caliper carrier.
8) Disconnect parking brake cable (1) from lever (2)
while rotating lever in direction of arrow.
9) Remove brake pads, slide pins and slide pin boots
from brake caliper carrier.
10) Remove brake caliper carrier (1) from rear axle (2).
Installation
1) Install brake caliper carrier (1) to rear axle (2).
Tightening torque
Brake caliper carrier bolt (a): 60 N·m (6.0 kgf-m,
43.5 lb-ft)
1
I6RS0B431008-01
1
4
2
3
I7RW01432009-01
1
2
I6RS0B431011-01
1
2
I7RW01432010-01
(a)
1
2
I7RW01432011-01