Suzuki 2006 SX4, Service Manual

Page: 663 / 1478

Automatic Transmission/Transaxle: 5A-75
Output Shaft Speed Sensor Inspection
S6RW0C5106016
1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor connector (2).
3) Check resistance between output shaft speed
sensor (1) terminals. If check result is not as
specified, replace sensor.
Output shaft speed sensor resistance
Standard: 344 – 516
Ω
at 20
°
C (68
°
F)
Input Shaft Speed Sensor Removal and
Installation
S6RW0C5106017
Removal
1) Remove battery and battery tray.
2) Disconnect input shaft speed sensor connector (2).
3) Remove input shaft speed sensor (1) by removing its
bolt.
Installation
1) Apply A/T fluid to new input shaft speed sensor O-
ring.
2) Install input shaft speed sensor (1) to A/T case and
tighten bolt to specified torque.
Tightening torque
Input shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
3) Connect input shaft speed sensor connector (2) to
input shaft speed sensor (1).
4) Install battery tray and battery.
Input Shaft Speed Sensor Inspection
S6RW0C5106018
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor connector (2).
3) Check resistance between input shaft speed sensor
(1) terminals. If check result is not as specified,
replace sensor.
Input shaft speed sensor resistance
Standard: 344 – 516
Ω
at 20
°
C (68
°
F)
Transmission Fluid Temperature Sensor
Removal and Installation
S6RW0C5106019
Removal
1) Disconnect negative cable at battery.
2) Disconnect transmission fluid temperature sensor
connector (1).
3. Transmission range sensor
2
1
I4RH01510030-01
2
3
1
I7RW01510037-01
3. Transmission range sensor
2
3
1
(a)
I7RW01510038-02
1
2
I4RH01510033-01
1
I7RW01510039-01