Suzuki 2006 SX4, Service Manual

Page: 266 / 1478

1D-35 Engine Mechanical:
Valves and Cylinder Head Components
S6RW0C1406027
Valves and Cylinder Head Removal and
Installation
S6RW0C1406028
Removal
1) Remove camshafts, tappets and shims. Refer to
“Camshafts, Tappet and Shim Removal and
Installation” for removal.
2) Loosen cylinder head bolts in such order as
numbered in figure and remove them.
NOTE
Don’t forget to remove cylinder head bolt
(M6) (3) as shown in figure.
I5JB0A142039-01
1. Cylinder block 7. Valve stem seal 13. Cylinder head bolt (M6)
: Be sure to tighten cylinder head bolt (M6) after securing
cylinder head bolt (M10).
2. Cylinder head 8. Valve spring 14. Knock pin
3. Cylinder head gasket
: Identification number provided on gasket comes
to crankshaft pully side, facing up.
9. Valve spring retainer : Tighten 52 N
⋅
m (5.2 kgf-m, 38.0 lb-ft), 82 N
⋅
m (8.2 kgf-m, 59.5
lb-ft), 0 N
⋅
m (0 kgf-m, 0 lb-ft), 52 N
⋅
m (5.2 kgf-m, 38.0 lb-ft)
and 103 N
⋅
m (10.3 kgf-m, 74.5 lb-ft) by the specified
procedure.
4. Intake valve 10. Valve cotter : 11 N
⋅
m (1.1 kgf-m, 8.0 lb-ft)
5. Exhaust valve 11. Valve guide : Do not reuse.
6. Valve spring seat 12. Cylinder head bolt (M10) : Apply engine oil to sliding surface of each part.
1. Crankshaft pulley side 2. Flywheel side
“5”
“4” “8” “10” “6” “2” 3, “1”
“9” “11” “7” “3”
1 2
I5JB0A142040-02