Suzuki 2006 SX4, Service Manual

Page: 614 / 1478

5A-26 Automatic Transmission/Transaxle:
Shift solenoid B (COM) (command signal of shift
solenoid valve - B) (ON, OFF)
ON: ON command being outputted to shift solenoid
valve-B.
OFF: ON command not being outputted to shift solenoid
valve-B.
TCC solenoid (COM) (command signal of torque
converter clutch solenoid valve) (ON, OFF)
ON: ON command being outputted to TCC solenoid
valve.
OFF: ON command not being outputted to TCC solenoid
valve.
Shift solenoid A (Mon) (monitor signal of shift
solenoid valve - A) (ON, OFF)
ON: Electricity being passed to shift solenoid valve-A.
OFF: Electricity not being passed to shift solenoid valve-
A.
Shift solenoid B (Mon) (monitor signal of shift
solenoid valve - B) (ON, OFF)
ON: Electricity being passed to shift solenoid valve-B.
OFF: Electricity not being passed to shift solenoid valve-
B.
TCC solenoid (Mon) (monitor signal of torque
converter clutch solenoid valve) (ON, OFF)
ON: Electricity being passed to TCC solenoid valve.
OFF: Electricity not being passed to TCC solenoid valve.
Brake switch (ON, OFF)
Brake light switch position detected by signal through
CAN communication line fed from ECM.
ON: Brake pedal depressed
OFF: Brake pedal released
MIL request (ON, OFF)
ON: Signal which TCM requires combination meter to
turn on MIL.
OFF: Signal which TCM does not require combination
meter to turn on MIL.
A/T Basic Check
S6RW0C5104009
This check is important for troubleshooting when TCM has detected no DTC and no abnormality has been noted in
visual inspection. Follow the flow table carefully.
Step Action Yes No
1 Was “A/T System Check” preformed? Go to Step 2. Go to “A/T System
Check”.
2 Perform “Road Test”
Is it OK?
Go to Step 3. Proceed to
“Troubleshooting” in
“Road Test”.
3 Perform “Manual Road Test”
Is it OK?
Go to Step 4. Proceed to
“Troubleshooting” in
“Manual Road Test”.
4 Perform “Engine Brake Test”
Is it OK?
Go to Step 5. Proceed to
“Troubleshooting” in
“Engine Brake Test”.
5 Perform “Stall Test”
Is it OK?
Go to Step 6. Proceed to
“Troubleshooting” in
“Stall Test”.
6 Perform “Time Lag Test”
Is it OK?
Go to Step 7. Proceed to
“Troubleshooting” in
“Time Lag Test”.
7 Perform “Line Pressure Test”
Is it OK?
Go to Step 8. Proceed to
“Troubleshooting” in
“Line Pressure Test”.
8 1) Proceed to “Trouble Diagnosis 1” in “A/T Symptom
Diagnosis”.
Is trouble identified?
Repair or replace faulty
parts. Go to Step 9.
9 1) Proceed to “Trouble Diagnosis 2” in “A/T Symptom
Diagnosis”.
Is trouble identified?
Repair or replace faulty
parts. Proceed to “Trouble
Diagnosis 3” in “A/T
Symptom Diagnosis”.