Suzuki 2006 SX4, Service Manual

Page: 672 / 1478

5A-84 Automatic Transmission/Transaxle:
7) Remove starting motor.
8) Remove bolts and nut fastening engine and
transaxle, then detach transaxle from engine.
NOTE
When detaching transaxle from engine, move
it in parallel with crankshaft and use care so
as not to apply excessive force to drive plate
and torque converter.
WARNING
!
Be sure to keep transaxle with torque
converter horizontal or facing up throughout
the work. Should it be tilted with torque
converter down, converter may fall off and
cause personal injury.
Remounting
1) Make sure that torque converter is installed correctly
to transaxle.
Refer to “Automatic Transaxle Unit Assembly”.
2) Attach transaxle to engine.
Tightening torque
Transaxle to engine bolts and nut (a): 85 N·m (
8.5 kgf-m, 61.5 lb-ft)
WARNING
!
Be sure to keep transaxle with torque
converter horizontal or facing up throughout
the work. Should it be tilted with torque
converter down, converter may fall off and
cause personal injury.
3) Tighten drive plate-torque converter bolts.
Align drive plate bolt hole and torque converter
through then tighten bolts through torque converter
housing lower plate opening.
Lock drive plate (1) by engaging a flat head rod or
the like (2) with drive plate gear.
Tightening torque
Drive plate to torque converter bolts (a): 23 N·m
(2.3 kgf-m, 16.5 lb-ft)
4) Install clutch housing plate.
Tighten clutch housing plate bolts (a) first and next
(b) with specified torque.
Tightening torque
Clutch housing plate bolt (M6) (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
Clutch housing plate bolt (M10) (b): 30 N·m (3.0
kgf-m, 21.5 lb-ft)
5) Install starter motor referring to “Starting Motor
Dismounting and Remounting in Section 1I”.
6) Install center shaft (1) to differential gear (for 2WD
vehicle). Tighten center bearing support bolts to
specified torque.
For tightening torque of center bearing support bolts,
refer to “Front Drive Shaft Assembly Components
Location in Section 3A”.
CAUTION
!
Be careful not to scratch oil seal lip with
center shaft while inserting.
7) Install engine rear mounting brackets and stiffener
(for 2WD vehicle).
8) Install transfer referring to “Transfer Dismounting
and Remounting in Section 3C” (for 4WD vehicle).
9) Remount engine with transaxle assembly to vehicle.
Refer to “Engine Assembly Removal and Installation
in Section 1D” for its procedure.
(a)
(a)
I7RW01510047-01
2
(a)
1
I7RW01510048-01
(b)
(a)
I7RW01510049-01