Suzuki 2006 SX4, Service Manual

Page: 289 / 1478

Engine Mechanical: 1D-58
c) Tighten bolts ((1) – (10)) to 40 N
⋅
m (4.0 kgf-m,
29.0 lb-ft) according to numerical order in figure.
d) In the same manner as in step c), retighten bolts
((1) – (10)) to 58 N
⋅
m (5.8 kgf-m, 42.0 lb-ft).
e) Tighten bolts ((11) – (22)) to specified torque
according to numerical order in figure.
Tightening torque
Crankcase bolt with 10 mm thread diameter
((1) – (10)): Tighten 40 N
⋅
m (4.0 kgf-m, 29.0
lb-ft), 0 N
⋅
m (0 kgf-m, 0 lb-ft), 40 N
⋅
m (4.0 kgf-
m, 29.0 lb-ft), 58 N
⋅
m (5.8 kgf-m, 42.0 lb-ft) by
the specified procedure
Crankcase bolt with 8 mm thread diameter
((11) – (22)): Tighten 26 N
⋅
m (2.6 kgf-m, 19.0
lb-ft) by the specified procedure
NOTE
• After tightening crankcase bolts, check to
be sure that crankshaft rotates smoothly
when turned by hand.
• Use new crankcase bolt (10 mm thread
diameter).
8) Pull out dowel pin (2) from crankshaft (1) and then
install rear oil seal (3) until it becomes flush with
cylinder block surface using special tools and plastic
hammer.
Special tool
(A): 09911–97710
(B): 09911–97811
9) Install dowel pin (2).
10) Install CKP sensor (1) and fix its wire harness with
bracket.
Tightening torque
CKP sensor bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
2. Crankshaft pulley side 3. Flywheel side
1
2 3
“5” “1”
“8”
“9”
“10”
“6”
“3”
“7”
“4” “2”
“16” “12” “14” “17”
“19”
“22”
“15”
“11” “18” “13”
“21”
“20”
I7RW01140071-01
4. Crankshaft side 5. Oil seal side
I5JB0A142058-01
I2RH01140179-01