Suzuki 2006 SX4, Service Manual

Page: 1343 / 1478

Security and Locks: 9F-10
Rear Door Lock Assembly Components
S6RW0C9606007
Rear Door Lock Assembly Removal and
Installation
S6RW0C9606008
Removal
1) Remove rear door glass referring to “Rear Door
Glass Removal and Installation in Section 9E”.
2) Disconnect door lock motor lead wire (If equipped).
3) Remove door latch mounting screws (1) and remove
door latch assembly (2).
Installation
Reverse removal procedure to install rear door lock
assembly referring to the following instruction and “Front
Door Lock Assembly Removal and Installation”.
• Tighten door latch screw to specified torque.
Tightening torque
Door latch screw (a): 5.0 N·m (0.5 kgf-m, 4.0 lb-ft)
• Install door trim referring to “Rear Door Glass
Removal and Installation in Section 9E”.
Rear Door Lock Assembly Inspection
S6RW0C9606009
• Check that door opens and closes smoothly and
properly.
• Check that door stops in the secondary latched
position properly (preventing door from opening
freely) and that door closes completely in the fully
latched position.
• Adjust door latch striker position referring to “Front
Door Lock Assembly Removal and Installation”, if
necessary.
(a)
(b)
1
6
2
5
3
4
I5RW0A960006-01
1. Outside handle
: Apply lithium grease 99000-25011 to sliding part.
4. Latch striker : 5.0 N
⋅
m
(0.5 kgf-m, 4.0 lb-ft)
2. Outside handle frame
: Apply lithium grease 99000-25011 to sliding part and spring.
5. Inside handle bezel : 10 N
⋅
m
(1.0 kgf-m, 7.5 lb-ft)
3. Rear door latch assembly
: Apply lithium grease 99000-25011 to sliding part.
6. Out side handle cap
1
2
I4RS0A960013-01
(a)
I4RS0A960014-01