Suzuki 2006 SX4, Service Manual

Page: 590 / 1478

5A-2 Automatic Transmission/Transaxle:
Part Inspection and Correction Table
General Description
A/T Description
S6RW0C5101001
This automatic transaxle is a full automatic type with 4-speed.
The torque converter is a 3-element, 1-step and 2-phase type and is equipped with an electronically controlled lock-up
mechanism. The gear shift device consists of 3 sets of planetary gear units, 3 disc type clutches, 3 disc type brakes, a
band type brake and 3 one-way clutches. The gear shift is done by selecting one of 7 positions (“P”, “R”, “N”, “D”, “3”,
“2” and “L”) by means of the select lever installed on the floor.
Part Inspect for Correction
Casted part, machined part Small flaw, burr Remove with oil stone
Deep or grooved flaw Replace part
Clogged fluid passage Clean with air or wire
Flaw on installing surface, residual gasket Remove with oil stone or replace
part
Crack Replace part
Bearing Unsmooth rotation Replace
Streak, pitting, flaw, crack Replace
Bushing, thrust washer Flaw, burr, wear, burning Replace
Oil seal, gasket Flawed or hardened seal ring Replace
Worn seal ring on its periphery or side Replace
Piston seal ring, oil seal, gasket, etc. Replace
Gear Flaw, burr Replace
Worn gear tooth Replace
Splined part Burr, flaw, torsion Correct with oil stone or replace
Snap ring Wear, flaw, distortion Replace
No interference Replace
Thread Burr Replace
Damage Replace
Spring Settling, sign of burning Replace
Friction plate Wear, burning, distortion, damaged claw Replace
Separator plate, retaining plate Wear, burning, distortion, damaged claw Replace
Sealing surface (where lip
contacts) Flaw, rough surface, stepped wear, foreign
material Replace