Suzuki 2006 SX4, Service Manual

Page: 565 / 1478

ABS: 4E-17
DTC C1013: Control Module Mismatch
S6RW0C4504012
Wiring Diagram
DTC Detecting Condition and Trouble Area
NOTE
When ABS hydraulic unit / control module assembly for 4WD model is installed to 2WD model, this
DTC is set. Replace to the correct ABS hydraulic unit / control module assembly.
Troubleshooting
WHT
GRN
1
2
3
4
E08-3
E08-6
GRN/BLK
GRN/YEL
GRN/ORN
12V
E08-9 GRN/ORN
5
6
[A] E08
1
2
3
4
5
6
7
12
13
14
15
16
17
18
19
20
21
22
8
9
10
11
23
24
25
26
I7RW01450005-04
[A]: ABS control module connector (viewed from terminal side) 3. Ignition switch 6. ABS hydraulic unit / control module assembly
1. Battery 4. Junction block assembly
2. Main fuse box 5. G sensor (4WD model)
DTC Detecting Condition Trouble Area
Abnormal signal is inputted to a no-used terminal of
control module while running or wrong ABS control
module is installed. • ABS control module
Step Action Yes No
1 1) Disconnect ABS hydraulic unit / control module
connector with ignition switch turned OFF.
2) Turn ignition switch to ON position.
3) Measure voltage between terminal of “E08-6” and
vehicle body ground.
Is it 0.3 V or more?
“GRN/YEL” wire short to
power source circuit. Substitute a known-
good ABS hydraulic unit
/ control module
assembly and recheck.