Suzuki 2006 SX4, Service Manual

Page: 1473 / 1478

Keyless Start System: 10E-29
Keyless Start Control Module Removal and
Installation
S6RW0CA506006
Removal
1) Disconnect negative cable at battery.
2) Remove glove box from instrument panel.
3) Disconnect connector from keyless start control
module.
4) Remove keyless start control module mounting bolt
and then remove keyless start control module (1)
from steering support member (2).
Installation
For installation, reverse removal procedure.
If keyless start control module is replaced, register ID
code of remote controller into keyless start control
module, referring to “Registration Procedure for Remote
Controller ID Code”.
Remote Controller Inspection
S6RW0CA506007
Check that remote controller operation indicator light (3)
lights up when lock (1) or unlock (2) button of remote
controller is pushed.
If it doesn’t light up in this check, replace battery and
then recheck. If it doesn’t light up even after battery
replacement, replace remote controller.
NOTE
When remote controller transmits lock,
unlock or panic signal, it makes operation
indicator light light up.
Replacement of Remote Controller Battery
S6RW0CA506008
If remote controller operation indicator light fails to light
up when lock or unlock button of remote controller is
pushed, replace its battery as follows.
1) If ignition key (1) is inserted in remote controller,
remove it.
2) With tip of flat blade screwdriver (2) put in slot (3) of
remote controller (4), pry it open.
3) Remove battery (4) from lower case (5).
CAUTION
!
Use care not to allow grease or dirt to be
attached on the printed circuit board and the
battery.
4) Replace the battery (lithium disc-type CR 2032 or
equivalent battery) so its (+) terminal faces on
remote controller lower case.
1
2
I5RW0AA50016-01
1 2
3
I4RS0BA50031-01
1. Upper case 3. Printed circuit board
2. Rubber switch
1
4
2
3
I4RS0BA50032-01
1
2
3
4
5
I4RS0BA50033-01