Suzuki 2006 SX4, Service Manual

Page: 218 / 1478

1B-5 Aux. Emission Control Devices:
EVAP Canister Removal and Installation
S6RW0C1206010
Removal
1) Disconnect negative cable at battery.
2) Hoist vehicle.
3) Remove EVAP canister as follows.
a) Disconnect hoses (1) from EVAP canister (2).
b) Remove EVAP canister bracket (3) with EVAP
canister from vehicle body.
c) Remove EVAP canister from EVAP canister
bracket.
Installation
Reverse removal procedure for installation noting the
following.
• When installing hoses, do not apply soap, grease or
oil to insertion part.
• For quick joint, push joint into pipe till joint lock clicks
and check that quick joint does not pull out without
unlocking joint lock.
EVAP Canister Inspection
S6RW0C1206011
WARNING
!
Do not suck nozzles on EVAP canister. Fuel
vapor inside EVAP canister is harmful.
1) Check outside of EVAP canister visually.
2) Disconnect vacuum hoses from EVAP canister.
3) Check that there is no restriction of flow through
purge pipe (1) and air pipe (2) when air is blown (4)
into tank pipe (3).
If any faulty condition is found in this inspection,
replace EVAP canister.
PCV Hose Inspection
S6RW0C1206014
Check hoses for connection, leakage, clog and
deterioration.
Replace as necessary.
PCV Valve Removal and Installation
S6RW0C1206015
Removal
1) Remove air cleaner referring to “Air Cleaner
Assembly Removal and Installation in Section 1D”.
2) Disconnect PCV hose from PCV valve.
3) Remove PCV valve from cylinder head cover.
Installation
Reverse removal procedure for installation noting the
following.
• Apply sealant to thread part of PCV valve (1).
“A”: Water tight sealant 99000–31250 (SUZUKI
Bond No.1207F)
• Tighten PCV valve to specified torque.
Tightening torque
PCV valve (a): 27 N·m (2.7 kgf-m, 19.5 lb-ft)
• Connect PCV hose to PCV valve securely.
I7RW01120014-01
I6RW0C120002-01
1, (a), “A”
I7RW01120005-01