Suzuki 2006 SX4, Service Manual

Page: 1295 / 1478

Instrumentation / Driver Info. / Horn: 9C-16
Fuel Level Sensor Removal and Installation
S6RW0C9306004
Removal
Remove fuel pump assembly referring to “Fuel Pump
Assembly Removal and Installation in Section 1G”.
Installation
Install fuel pump assembly referring to “Fuel Pump
Assembly Removal and Installation in Section 1G”.
Fuel Level Sensor Inspection
S6RW0C9306005
• Check that resistance between terminals “a” and “b”
of fuel level sensor changes with change of float
position.
• Check resistance between terminals “a” and “b” at
each float position in the following.
If the measured value is out of specification, replace.
Fuel level sensor specifications
Oil Pressure Switch Removal and Installation
S6RW0C9306006
For removal and installation, refer to “Oil Pressure
Check in Section 1E”.
Oil Pressure Switch Inspection
S6RW0C9306007
1) Disconnect oil pressure switch (1) lead wire.
2) Check for continuity between oil pressure switch
terminal (2) and cylinder block (3) as shown.
If check result is not as specified, replace oil
pressure switch (1).
Oil pressure sensor specification
During engine running: No continuity
At engine stop: Continuity
Engine Coolant Temperature (ECT) Sensor
Inspection
S6RW0C9306008
Check engine coolant temperature sensor for resistance,
refer to “Engine Coolant Temperature (ECT) Sensor
Inspection in Section 1C”.
Float Position Resistance (
Ω
)
Full Upper “c”
204 mm
(8.03 in.)
40
±
2
Full Lower “d”
32 mm
(1.26 in.)
280
±
3.3
1. Fuel pump 2. Float
“c”
“d”
“b” “a”
1
2
I7RW01930008-01
I7RW01930009-01