Suzuki 2006 SX4, Service Manual

Page: 649 / 1478

Automatic Transmission/Transaxle: 5A-61
Connector “C06”
Terminal Wire color Circuit
Standard
voltage
Condition
C06-1 BLK Ground for TCM 0 – 1 V Ignition switch is at ON position.
C06-2
LT GRN/
BLK
Ground for pressure control
solenoid valve
0.6 – 1.0 V Ignition switch is at ON position.
C06-3 — — — —
C06-4 GRY
Output for pressure control
solenoid valve
* 0 – 1 V
↑↓
10 – 14 V
(“Reference
waveform
No. 1: ”)
Engine is running at idle speed.
(Output signal is duty pulse. Duty ratio varies
depending on throttle valve opening.)
C06-5 WHT/BLU
Output for TCC pressure
control solenoid valve
* 0 – 1 V
↑↓
10 – 14 V
(“Reference
waveform
No. 2: ”)
Vehicle is running.
(Sensor signal is pulse. Pulse frequency varies
depending on vehicle condition.)
C06-6 YEL/BLK Main power source 10 – 14 V Ignition switch is at ON position.
C06-7 WHT
CAN communication line
(active low signal)
* 0.5 – 2.5 V
(“Reference
waveform
No. 3: ”)
Ignition switch is at ON position.
(CAN communication line signal is pulse. Pulse
signal frequency varies depending on engine
condition.)
C06-8 — — — —
C06-9 — — — —
C06-10 — — — —
C06-11 LT GRN
Signal for transmission fluid
temperature sensor
2.9 – 3.1 V
Ignition switch is at ON position and transmission
fluid temperature is 20
°
C (68
°
F).
0.3 – 0.5 V
Ignition switch is at ON position and transmission
fluid temperature is 100
°
C (212
°
F).
C06-12 ORN
Ground for transmission
fluid temperature sensor
0 – 1 V Ignition switch is at ON position.
C06-13 — — — —
C06-14 — — — —
C06-15 BLK/YEL
Shift solenoid valve – B
(No. 2)
10 – 14 V
Ignition switch is at ON position and select lever is
at other than “P”, “R” or “N” range.
C06-16 BRN
Shift solenoid valve – A
(No. 1)
0 – 1 V
Ignition switch is at ON position and select lever is
all ranges.
C06-17 RED
CAN communication line
(active high signal)
* 2.5 – 4.5 V
(“Reference
waveform
No. 3: ”)
Ignition switch is at ON position.
(CAN communication line signal is pulse. Pulse
signal frequency varies depending on engine
condition.)
C06-18 — — — —
C06-19 — — — —
C06-20 — — — —
C06-21 — — — —
C06-22 — — — —
C06-23 BLK Ground for TCM 0 – 1 V Ignition switch is at ON position.
C06-24 WHT/RED Power source for back-up 10 – 14 V Ignition switch is at ON position.