Suzuki 2006 SX4, Service Manual

Page: 490 / 1478

3C-3 Transfer:
Transfer Dismounting and Remounting
S6RW0C3306003
Dismounting
1) Disconnect negative (–) cable at battery.
2) Drain transaxle oil and transfer oil.
3) Remove drive shaft assembly referring to “Front
Drive Shaft Assembly Removal and Installation in
Section 3A”.
4) Remove exhaust No.1, No.2 and center pipes
referring to “Exhaust Pipe and Muffler Removal and
Installation in Section 1K”.
5) Remove propeller shaft referring to “Propeller Shaft
Assembly Removal and Installation in Section 3D”.
6) Remove engine rear mounting upper nut (1), lower
nut (3) and stiffeners (2).
7) Carry out Step 2) to 12) of “Removal” under “Front
Suspension Frame, Stabilizer Bar and/or Bushing
Removal and Installation (2WD Model) in Section
2B” in order to lower transfer with front suspension
frame.
8) Remove front suspension frame front mounting bolt
and loosen front suspension frame rear mounting
bolt a little.
9) Remove transfer to transaxle bolts (1) and nut (3) (A/
T model), and then separate transfer (2) with engine
rear mounting from transaxle.
NOTE
When separate transfer and engine rear
mounting from transaxle, check front
suspension frame for dent. If any dent is
found on it, apply rust retardant it.
10) Remove front suspension frame rear bolt.
CAUTION
!
When removing transfer, be careful not to
drop it. Otherwise, transfer damage and
personal injury may result.
11) Lower front suspension frame with steering gear
case and transfer, and then remove transfer.
3. Transfer
4. Engine rear mounting
5. Front suspension frame
1
2
3
4
1
4
5
2
I7RW01330001-01
1
3
2
1
I7RW01330002-01