Suzuki 2006 SX4, Service Manual

Page: 1393 / 1478

Cruise Control System: 10A-2
Components and Functions of Cruise Control System
S6RW0CA101002
Component Function
ECM and electric throttle body ECM executes centralized control over all functions including setting a constant speed,
resuming it, setting coast, cancelling cruise control limiting minimum speed.
ECM controls electric throttle valve opening to keep actual vehicle speed at set (target)
speed.
MAIN (ON/OFF) switch This switch has a momentary contact type button to press cruise control
system ON and OFF.
SET/COAST switch When this switch is pressed (ON) and then released (OFF) while vehicle is running at
a speed 40 km/h (25 mile/h) or higher, vehicle speed at that OFF moment is stored in
memory and it is maintained (constant cruising).
Pressing this switch (ON) continuously during constant cruising keeps slowing down
vehicle speed as long as it is ON. When it is released (OFF), vehicle speed at that
moment is stored in memory and vehicle starts constant cruising.
Pushing this switch during constant cruising decreases vehicle speed according to
number of times the switch is pushed.
RES/ACC switch When this switch is pressed (ON) during constant cruising, vehicle speed keeps
increasing as long as it is ON. When it is released (OFF), vehicle speed at that
moment is stored in memory and vehicle starts constant cruising. If vehicle speed is
higher than 40 km/h (25 mile/h) after cruise control is cancelled, pressing this switch
ON momentarily will resume the speed at which vehicle was running before
cancellation.
Pushing this switch during constant cruising increases vehicle speed according to
number of times the switch is pushed.
CANCEL switch When this switch is pressed (ON), cruise control (throttle valve control) is cancelled.
Wheel speed sensor
(vehicle speed signal) ECM receives speed sensor signal from ABS control module through CAN
communication and calculates vehicle speed using that signal.
Brake light switch Brake light switch has 2 contact points. One contact point closes when brake pedal is
depressed to light brake light and provides a voltage signal to the ECM.
The other contact point (brake pedal position switch) opens when brake pedal is
depressed, to shut off power to cruise control of ECM, thereby cancelling cruise
control (throttle valve control).
This switch is installed to cancel cruise control (constant cruising).
Clutch pedal position switch
(M/T model) When clutch pedal is depressed, clutch pedal position switch closes and provides a
ground signal to ECM.
ECM cancels cruise control (throttle valve control) when this signal is inputted.
Transmission range switch
(A/T model) When selector lever is placed in either “P”, “R” or “N” position, transmission range
switch closes and provides a ground signal to TCM. TCM transmits signal from
transmission range switch to ECM through CAN communication. When ECM receives
a signal indicating that selector lever position is “P”, “R” or “N”, it cancels cruise control
(throttle valve control).
TCM (A/T model) TCM receives the SET signal for the cruise control from ECM through CAN
communication. When TCM receives the SET signal from ECM, the gear shift control
is performed by using the gear shift map for the cruise control changed from the one
for normal gear shift. For details, refer to “Automatic Gear Shift Table in Section 5A”.
“CRUISE” indicator light In the state with ignition switch ON and cruise control system OFF, pressing MAIN
(ON/OFF) switch once and releasing it will activate the cruise control system and ECM
will cause indicator light to light up.
“SET” indicator light It lights up when cruise control (throttle valve control) is functioning.