Suzuki 2006 SX4, Service Manual

Page: 1398 / 1478

10A-7 Cruise Control System:
Repair Instructions
Cruise Control Switch Removal and Installation
S6RW0CA106001
For removal and installation, refer to “Remote Audio
Control Switch Removal and Installation (If Equipped) in
Section 9C”.
Cruise Control Switch Inspection
S6RW0CA106002
NOTE
Never disassemble cruise control switch.
Disassembly will spoil its original functions.
1) Remove driver air bag (inflator) module referring to
“Driver Air Bag (Inflator) Module Removal and
Installation in Section 8B”.
2) Disconnect cruise control switch connector (1) from
control coil.
3) Check cruise control switch as follows.
For MAIN (ON/OFF) Switch
Check for continuity between “1” and “8” terminals under
each condition below.
If check result is not satisfactory, replace cruise control
switch (2).
Cruise MAIN (ON/OFF) switch (3) specification: [B]
Switch button released: Infinity
Switch button pressed: Continuity
For SET/COAST, RES/ACC and CANCEL Switch
Check for resistance between “7” and “9” terminals
under each condition below.
If check result is not satisfactory, replace cruise control
switch (2).
SET/COAST, RES/ACC and CANCEL switches
resistance: [C]
All switches released (OFF): Infinity
CANCEL switch (4) pressed (ON): About 0
Ω
SET/COAST switch (5) pressed (ON): 213 – 227
Ω
RES/ACC switch (6) pressed (ON): 882 – 938
Ω
CPP Switch (for Cruise Control) Removal and
Installation
S6RW0CA106003
Removal
1) Disconnect connector of CPP switch (for cruise
control) (1) with ignition switch OFF.
2) Remove CPP switch (for cruise control) (1) from
pedal bracket.
[A]: Cruise control switch connector viewed from harness side
2. Brake light switch
1 5 3 6
8 9
1 5 3 6
7 8 9
[B] [C]
[A]
6
4
5
3
1
2
I7RW01A10005-01
1
2
I7RW01A10006-01