Suzuki 2006 SX4, Service Manual

Page: 85 / 1478

Engine General Information and Diagnosis: 1A-41
)
P0327 Knock Sensor 1 Circuit Low • ECM stops knock control.
• ECM controls fuel cut at specified engine
speed.
) P0328 Knock Sensor 1 Circuit High
) P0335 Crankshaft Position (CKP) Sensor “A” Circuit
• ECM controls ignition timing.
• ECM controls fuel cut at specified engine
speed.
) P0340 Camshaft Position (CMP) Sensor “A” Circuit
• ECM controls ignition timing.
• ECM controls fuel cut at specified engine
speed.
• ECM stops knock control.
) P0500 Vehicle Speed Sensor “A” (VSS)
• ECM controls actuators assuming that vehicle
speed is 0 km/h (0 mph).
• ECM stops IAC feedback control.
) P0532 A/C Refrigerant Pressure Sensor “A” Circuit Low
ECM stops A/C control.
) P0533 A/C Refrigerant Pressure Sensor “A” Circuit High
) P0607 Control Module Performance
• ECM turns off throttle actuator control relay
and throttle valve is fixed at the opening of
about 7
°
from its completely closed position
(default opening).
• ECM controls fuel cut at specified engine
speed.
) P0660 Intake Manifold Tuning Valve Control Circuit/Open
ECM stops IMT valve control.
) P0662 Intake Manifold Tuning Valve Control Circuit High
) P2101
Throttle Actuator Control Motor Circuit Range /
Performance • ECM turns off throttle actuator control relay
and throttle valve is fixed at the opening of
about 7
°
from its completely closed position.
(default opening).
• ECM controls fuel cut at specified engine
speed.
) P2102 Throttle Actuator Control Motor Circuit Low
) P2103 Throttle Actuator Control Motor Circuit High ECM controls fuel cut at specified engine speed.
) P2111 Throttle Actuator Control System - Stuck Open
• ECM turns off throttle actuator control relay
and throttle valve is fixed at the opening of
about 7
°
from its completely closed position
(default opening).
• ECM controls fuel cut at specified engine
speed.
) P2119
Throttle Actuator Control Throttle Body Range /
Performance
• ECM turns off throttle actuator control relay
and throttle valve is fixed at the opening of
about 7
°
from its completely closed position
(default opening).
• ECM controls fuel cut at specified engine
speed.
) P2122
Throttle/Pedal Position Sensor/Switch “D” Circuit
Low Input
Lower upper limit of accelerator demand target
throttle opening.
) P2123
Throttle/Pedal Position Sensor/Switch “D” Circuit
High Input
) P2127
Throttle/Pedal Position Sensor/Switch “E” Circuit
Low Input
) P2128
Throttle/Pedal Position Sensor/Switch “E” Circuit
High Input
) P2135
Throttle/Pedal Position Sensor/Switch “A” / “B”
Voltage Correlation • ECM turns off throttle actuator control relay
and throttle valve is fixed at the opening of
about 7
°
from its completely closed position
(default opening).
• ECM controls fuel cut at specified engine
speed.
) P2138
Throttle/Pedal Position Sensor/Switch “D” / “E”
Voltage Correlation
DTC No. Detected item Fail-safe operation