Suzuki 2006 SX4, Service Manual

Page: 662 / 1478

5A-74 Automatic Transmission/Transaxle:
Adjustment
1) Shift manual shift lever (1) to “N” range.
2) Connect ohmmeter between 6 and 10 terminals of
disconnected transmission range sensor connector
(3).
3) Turn transmission range sensor (2) gradually to find
position where ohmmeter reading indicates
continuity. Then fix transmission range sensor (2) at
that position by tightening bolts and nut to specified
torque.
Tightening torque
Transmission range sensor bolt (a): 25 N·m (2.5
kgf-m, 18.0 lb-ft)
Transmission range sensor nut (b): 7.5 N·m (
0.75 kgf-m, 5.5 lb-ft)
4) Connect transmission range sensor connector (3).
5) Check that engine starts in “N” and “P” ranges but it
doesn’t start in “D”, “3”, “2”, “L” or “R” range. Also,
check that back-up light turn ON in “R” range.
Output Shaft Speed Sensor Removal and
Installation
S6RW0C5106015
Removal
1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor connector (2).
3) Remove output shaft speed sensor (1) by removing
its bolt.
Installation
1) Apply A/T fluid to new output shaft speed sensor O-
ring.
2) Install output shaft speed sensor (1) to A/T case and
tighten bolt to specified torque.
Tightening torque
Output shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
3) Connect output shaft speed sensor connector (2) to
output shaft speed sensor (1).
4) Connect negative cable to battery.
3
1
2
9
4
6
8
3
5
7
10
"L"
"2"
"D"
"R"
"N"
"P"
(b)
(a)
2
1
I5RH01510008-01
3. Battery
3. Battery
1 2
3
I7RW01510035-01
1
(a)
2
3
I7RW01510036-01