Suzuki 2006 SX4, Service Manual

Page: 818 / 1478

6C-16 Power Assisted Steering System:
“EPS” Warning Light Does Not Come ON with Ignition Switch Turned ON before Engine Starts
S6RW0C6304010
Wiring Diagram
Circuit Description
Operation (ON/OFF) of “EPS” warning light is controlled by P/S control module through combination meter.
If the P/S system is in good condition, P/S control module turns “EPS” warning light ON at the ignition switch ON, and
then turns it OFF at the engine start. If an abnormality in the system is detected, “EPS” warning light is turned ON
continuously by P/S control module. If P/S control module is disconnected, “EPS” warning light is not turned ON.
8 Scan tool operation check
1) Check if communication is possible by making
communication with other vehicles.
Is it possible to communicate with the other vehicle?
Scan tool is in good
condition, check
intermittent trouble
referring to “Intermittent
and Poor Connection
Inspection in Section
00”. Recheck PCMCIA card
and DLC cable for faulty
condition. If they are
OK, scan tool is faulty.
Step Action Yes No
[A]
1 2
3 4 5 6 7 8 9
11
10
12 13 14 15 16 17 18 19 20
1
2
[B]
10 9 8 7 6 5 4 3 2 1 16 15 14 13 12 11
26 25 24 23 22 21 20 19 18 17 32 31 30 29 28 27
[C]
LT GRN/BLK
E11-1
E13-1
GRN
GRN
WHT
7
8
3
11
12
13
5
6
10
4
1
2
12V
E13-2
BLK
G241-31
RED/BLK
G241-25 E11-5 GRY
9
I6RW0C630003-01
[A]: P/S control module connector No.1 “E11” (viewed from harness side) 4. Main fuse 10. “IGN” fuse
[B]: P/S control module connector No.2 “E13” (viewed from harness side) 5. Combination meter 11. “P/S” fuse
[C]: Combination meter connector “G241” (viewed from harness side) 6. “EPS” warning light 12. “IG1 SIG” fuse
1. Main fuse box 7. P/S control module 13. “MTR” fuse
2. Ignition switch 8. Individual circuit fuse box No.1
3. Junction block assembly 9. “EPS” warning light circuit