Suzuki 2006 SX4, Service Manual

Page: 727 / 1478

Automatic Transmission/Transaxle: 5A-139
77) Measure end play of input shaft (1), using special
tool. If end play is out of specification, replace input
shaft rear thrust bearing front race in the following so
as end play to be in standard value.
Special tool
(A): 09900–20607
(B): 09900–20701
End play of input shaft
Standard: 0.37 – 0.90 mm (0.0034 – 0.035 in.)
Available input shaft rear thrust bearing front
race thickness
0.81 mm (0.031 in.), 1.15 mm (0.045 in.)
78) Apply A/T fluid to new gaskets (1) and install gaskets
(1) to transaxle case.
79) While holding valve body assembly, connect manual
valve connecting rod (1) to manual shift shaft (2).
80) Install valve body assembly (3) by 9 tightening bolts
to specified torque.
Tightening torque
Valve body bolt: 10 N·m (1.0 kgf-m, 7.5 lb-ft)
81) Apply A/T fluid to new O-ring and install O-ring to
solenoid harness (1).
82) Install solenoid harness (1) into transaxle case.
NOTE
Do not twist or deviate O-ring during
installation.
83) Connect solenoid connectors by identifying wire
color.
Solenoid coupler: Wire color
Pressure control solenoid valve (1): Blue + Brawn
Shift solenoid valve–A (No. 1) (2): White
Shift solenoid valve–B (No. 2) (3): Black
TCC solenoid valve (4): Yellow
84) Clamp solenoid harness.
Bolt Length (mm) Pieces
A 16 2
B 50 4
C 55 3
(A)
(B)
1
I4RH01510234-01
1
I4RH01510060-01
5. Harness clamp
A
A
B
B
B
C
C
C
3
2
1
I5RH01510021-01
3
2
5
1
4
I4RH01510236-01