Suzuki 2006 SX4, Service Manual

Page: 631 / 1478

Automatic Transmission/Transaxle: 5A-43
DTC P0717: Input Speed Sensor “A” Circuit No Signal
S6RW0C5104023
Wiring Diagram
DTC Detecting Condition and Trouble Area
3 Check transmission fluid temperature sensor circuit for
IG short
1) Cool down A/T fluid temperature under ambient
temperature.
2) Connect TCM connectors to TCM with ignition switch
turned OFF.
3) Turn ignition switch to ON position.
4) Measure voltage between terminal “C06-11” of TCM
connector and ground.
Is it 5 V or more?
“LT GRN” circuit shorted
to power circuit. If circuit
is OK, go to Step 4. Intermittent trouble or
faulty TCM. Check for
intermittent referring to
“Intermittent and Poor
Connection Inspection
in Section 00”. If OK,
substitute a known-
good TCM and recheck.
4 Check transmission fluid temperature sensor
1) Check transmission temperature sensor for resistance
referring to “Transmission Fluid Temperature Sensor
Inspection”.
Is it in good condition?
Intermittent trouble or
faulty TCM. Check for
intermittent referring to
“Intermittent and Poor
Connection Inspection
in Section 00”. If OK,
substitute a known-
good TCM and recheck. Replace transmission
fluid temperature
sensor.
Step Action Yes No
2.5V
6 5
16 15 14 13 12 11
4 3
24 23 21 22
10 9 8 7
2 1
19 20 18 17
C06
1
2
3
17 16
26 25
15 14
6 5 3 4 2
13 12
23 22 24
11 10 9
21 20 19
8 7
18
1
C07
C07-6
C07-16 WHT
BLK
I7RW01510010-01
1. TCM 3. Terminal arrangement of TCM connector (viewed from harness side)
2. Input shaft speed sensor
DTC detecting condition Trouble area
Pulse signals of input shaft speed sensor are not input although
pulse signals of output shaft speed sensor are input while
vehicle is running.
(1 driving cycle detection logic) • Input shaft speed sensor or its circuit malfunction.
• Improper input shaft speed sensor installation.
• Damaged forward and direct clutches drum.
• Foreign material attachment to sensor or drum.
• TCM