Suzuki 2006 SX4, Service Manual

Page: 616 / 1478

5A-28 Automatic Transmission/Transaxle:
Manual Road Test
S6RW0C5104011
WARNING
!
• Carry out test in very little traffic area to prevent an accident.
• Test requires 2 persons, a driver and a tester.
The purpose of this test is to judge whether causal factor of trouble which occurred in automatic transaxle is electrical
or mechanical by disconnecting valve body harness connector (1) and fixing automatic transaxle gear position.
1) Start engine and warm it up to normal operating temperature.
2) Turn ignition switch to OFF position and disconnect valve body harness connector (1).
3) Turn OFF all electrical loads.
With select lever shifted to each range (“L”, “2”, “3” and “D”), drive vehicle at 1,000 rpm engine speed and then
check vehicle speed by referring to “Fixed gear position”.
If vehicle speed is not as specified in “Fixed gear position” table, go to troubleshooting.
4) Connect valve body harness connector and clear DTC.
Fixed gear position
Troubleshooting
Select lever position Fixed gear position Vehicle speed
L range 1st gear Approx. 11.31 km/h (7.0 mile/h)
2 range 3rd gear Approx. 29.87 km/h (18.6 mile/h)
3 range
4th gear Approx. 41.55 km/h (25.8 mile/h)
D range
R range
Reverse gear Approx. 10.33 km/h (6.4 mile/h)
I7RW01510007-01
Condition Possible cause Correction / Reference Item
Selected gear is not
correct Faulty valve body component Replace valve body.
Faulty clutch or brake Inspect clutch and brake. If any parts are faulty,
replace them.