Suzuki 2006 SX4, Service Manual

Page: 612 / 1478

5A-24 Automatic Transmission/Transaxle:
Scan Tool Data
S6RW0C5104008
As the data values given in the following table are standard values estimated on the basis of values obtained from the
normally operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good
condition, there may be cases where the checked value does not fall within each specified data range. Therefore,
judgment as abnormal should not be made by checking with these data alone.
Also, condition in the following table that can be checked by the scan tool are those detected by TCM and output from
TCM as commands and there may be cases where the automatic transaxle or actuator is not operating (in the
condition) as indicated by the scan tool.
) U0100
Lost Communication With
ECM / PCM “A”
TCM is controlled as follows.
• Line pressure is controlled to maximum pressure.
• Lock-up function is inhibited.
• TCM assumes throttle position signal to be 100%.
• TCM assumes engine speed to be 0 RPM.
• After 15 minutes pass from detecting malfunction, TCM assumes
engine coolant temperature to be 90
°
C (194
°
F).
• Gear position is fixed according to select lever position as follows.
– D range: Fixed to 4th gear position
– 3 range: Fixed to 4th gear position
– 2 range: Fixed to 3rd gear position
– L range: Fixed to 1st gear position
DTC No. Trouble area Fail safe operation
Scan tool data Vehicle condition
Normal condition / reference
values
) Input shaft
revolution
Ignition switch ON and engine stop 0 RPM
At 60 km/h (37.5 mile/h) constant speed, 20% or less
throttle opening and 3rd gear (“3” range) 2300 RPM
(displayed in increments of 50 rpm)
) Output shaft
revolution
At vehicle stop 0 RPM
At 60 km/h (37.5 mile/h) constant speed, 20% or less
throttle opening and 3rd gear (“3” range) 2300 RPM
(displayed in increments of 50 rpm)
) Battery voltage Ignition switch ON and engine stop Battery voltage is displayed
) ATF temperature Ignition switch ON and engine stop A/T fluid temperature is displayed
) Pressure control Sol At specified idle speed after warming up 0%
) Vehicle speed — Vehicle speed is displayed
) Gear position
Ignition switch ON and select lever is in “P” position P or N
Ignition switch ON and select lever is in “R” position R
Ignition switch ON and select lever is in “N” position P or N
Ignition switch ON and select lever is in “D” position 1
Ignition switch ON and select lever is in “3” position 1
Ignition switch ON and select lever is in “2” position 1
Ignition switch ON and select lever is in “L” position 1
) Throttle position
Ignition switch ON and select pedal released 0 – 12%
Ignition switch ON and select pedal depressed fully 90 – 100%
) Accel actual
position
Ignition switch ON and select pedal released 0 – 12%
Ignition switch ON and select pedal depressed fully 90 – 100%
) Engine speed At specified idle speed after warming up
Engine revolution speed is
displayed
) Coolant
temperature
Ignition switch ON and engine stop
Engine coolant temperature is
displayed
) Cruise control signal
Ignition switch ON and cruise control switch OFF OFF
Ignition switch ON and cruise control switch ON ON
) Transaxle range Ignition switch ON and engine stop Select lever position is displayed
) “3” position switch
Ignition switch ON and select lever to “3” or “2” range ON
Ignition switch ON and select lever to other than “3” or
“2” range
OFF