Suzuki 2006 SX4, Service Manual

Page: 339 / 1478

Fuel System: 1G-18
Main Fuel Level Sensor Removal and
Installation
S6RW0C1706018
CAUTION
!
• Do not touch resister plate (1) and deform
arm (2). It may cause main fuel level sensor
to fail.
• Be very careful not to cause damage to
fuel tube installed section (sealed section
in bore). If it be damaged, replace it with
new one, or fuel will leak from the part.
Removal
1) Remove fuel pump assembly from fuel tank referring
to “Fuel Pump Assembly Removal and Installation”.
2) Disconnect main fuel level sensor connector (3).
3) With pressing snap-fit part (2), remove main fuel
level sensor (1) by sliding it in the arrow direction as
shown in figure.
Installation
Reverse removal procedure for installation.
Fuel Pump Inspection
S6RW0C1706019
• Check fuel pump assembly for damage.
• Check fuel suction filter for evidence of dirt and
contamination.
If present, replace or clean and check for presence of
dirt in fuel tank.
• For electrical circuit, refer to “Fuel Pressure Check in
Section 1A”.
• For inspection of main fuel level sensor (1), refer to
“Fuel Level Sensor Inspection in Section 9C”.
1
2
I4RS0A170016-01
1
3
1
2
I5JB0A171026-01
1
I5JB0A171027-01