Suzuki 2006 SX4, Service Manual

Page: 1302 / 1478

9C-23 Instrumentation / Driver Info. / Horn:
Remote Audio Control Switch Inspection (If
Equipped)
S6RW0C9306025
1) Remove driver air bag (inflator) module referring to
“Driver Air Bag (Inflator) Module Removal and
Installation in Section 8B”.
2) Disconnect remote audio control switch connector
from contact coil.
3) Check switch for resistance between “a” and “b”
terminals under each condition below.
If check result is not satisfactory, replace remote
audio control switch.
Remote audio control switch resistance
All switches released (OFF): 5119 – 5223
Ω
Switch “1” pushing on (ON): 55 – 57
Ω
Switch “2” pushing on (ON): 129 – 133
Ω
Switch “3” pushing on (ON): 238 – 244
Ω
Switch “4” pushing on (ON): 416 – 426
Ω
Switch “5” pushing on (ON): 743 – 759
Ω
Switch “6” pushing on (ON): 1555 – 1587
Ω
Vehicle Speed Signal Inspection (For Audio
Unit) (If Equipped)
S6RW0C9306026
Check vehicle speed pulse output signal of BCM
referring to “Reference waveform No.7” under
“Inspection of BCM and Its Circuits in Section 10B”.
Specifications
Tightening Torque Specifications
S6RW0C9307001
NOTE
The specified tightening torque is also described in the following.
“Audio System Component Location”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fasteners Information in Section 0A”.
[A]: With cruise control system
[B]: Without cruise control system
1
2
3
4
5
6
“b” “a”
“b” “a”
[A]
[B]
I6RW0C930004-01
Fastening part
Tightening torque
Note
N
⋅
m kgf-m lb-ft
Instrument panel mounting bolt 23 2.3 17.0 )
Antenna base mounting bolt 5.0 0.5 4.0 )