Suzuki 2006 SX4, Service Manual

Page: 724 / 1478

5A-136 Automatic Transmission/Transaxle:
55) Apply A/T fluid to 4 new gaskets (1).
56) Install 4 new gaskets (1) to transaxle case.
57) Apply A/T fluid to transaxle lubrication tubes (2).
58) Install tube clamp (3) and tighten the torx
®
bolt to
specified torque.
Tightening torque
Tube clamp torx
®
bolt (a): 9 N·m (0.9 kgf-m, 6.5
lb-ft)
59) Apply petroleum jelly to input shaft rear thrust
bearing rear race (1).
60) Place input shaft rear thrust bearing rear race (1) to
transaxle rear cover (2).
61) Apply sealant to mating surface of transaxle case by
using a nozzle as shown in figure by such amount
that its section is 1.5 mm (0.059 in.) in diameter.
“A”: Sealant 99000–31230 (SUZUKI Bond
No.1216B)
62) Install transaxle rear cover to transaxle case by a
tightening bolts to specified torque.
NOTE
Make sure to use new transaxle rear cover
bolts A, B and D.
Tightening torque
Transaxle rear cover bolts (a): 10 N·m (1.0 kgf-
m, 7.5 lb-ft)
Transaxle rear cover bolts (b): 24 N·m (2.4 kgf-
m, 17.5 lb-ft)
63) Apply A/T fluid to inner surface of new countershaft
front bearing (1).
64) Install new countershaft front bearing (1) to transaxle
housing, using special tool.
Special tool
(A): 09913–75510
3
(a)
2
1
I4RH01510222-01
2
1
I4RH01510223-01
"A"
I4RH01510224-01
Bolt Size Length (mm) Pieces
A M6 16 2
B M8 25 2
C M8 45 4
D M8 48 3
A, (a)
A, (a)
B, (b)
B, (b)
D, (b)
D, (b)
C, (b)
I4RH01510225-01
A
1
I4RH01510226-01