Suzuki 2006 SX4, Service Manual

Page: 685 / 1478

Automatic Transmission/Transaxle: 5A-97
4) Using special tool and hydraulic press (1), compress
2nd coast brake piston return spring (2) until spring
seat is pushed down to 1 – 2 mm (0.039 – 0.078 in.)
lower than snap ring groove and remove snap ring
(3).
Special tool
(A): 09926–98350
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of 2nd
coast brake piston return spring to deform.
5) Remove 2nd coast brake piston return spring (2).
6) Remove 2nd coast brake piston (1) with O-rings by
applying compressed air (400 – 800 kPa, 4 – 8 kg/
cm
2 , 57 – 113 psi) from through oil hole (2).
NOTE
If piston does not pop out, it is recommended
to use needle-nose pliers for removal.
7) Remove snap ring (1), using flat end rod or the like.
8) Remove retaining plate, friction plates, separator
plates and cushion plate.
9) Remove 2nd brake piston return spring (2).
10) Remove 2nd brake piston (1) with O-rings applying
compressed air (400 – 800 kPa, 4 – 8 kg/cm 2 , 57 –
113 psi) from through oil hole (2).
NOTE
If piston does not pop out, it is recommended
to use needle-nose pliers for removal.
11) Remove stator shaft (1) by removing 14 bolts (2).
1
(A)
3
2
I4RH01510092-01
1
2
I4RH01510093-01
1
2
I4RH01510094-01
1
2
I4RH01510095-01
2, (b)
2, (b)
2, (b)
2, (a)
2, (b)
1
I4RH01510096-01