Suzuki 2006 SX4, Service Manual

Page: 1399 / 1478

Cruise Control System: 10A-8
Installation
1) Install CPP switch (for cruise control) (2) to pedal
bracket.
2) With clutch pedal (1) released, adjust switch position
so that clearance between end of thread and clutch
pedal bracket is within specification.
Clearance between end of thread and clutch
pedal bracket
“a”: 1.5 – 2.0 mm (0.06 – 0.08 in.)
3) Tighten lock nut (3) to specified torque.
Tightening torque
CPP switch lock nut (a): 7.5 N·m (0.75 kgf-m, 5.5
lb-ft)
4) Connect connector to CPP switch (for cruise control)
securely.
Clutch Pedal Position (CPP) Switch (for Cruise
Control) Inspection and Adjustment
S6RW0CA106004
Inspection
Check for resistance between terminals under each
condition below. If check result is not satisfactory,
replace.
CPP switch (for cruise control) resistance
When switch shaft is pushed [A]: No continuity
When switch shaft is free [B]: Continuity
Adjustment
For adjustment, refer to “Installation” under “CPP Switch
(for Cruise Control) Removal and Installation”.
Brake Light Switch Removal and Installation
S6RW0CA106005
For removal and installation, refer to “Brake Light Switch
Adjustment in Section 4A”.
Brake Light Switch Inspection
S6RW0CA106006
Check for continuity between terminals referring to
“Brake Light Switch Inspection in Section 9B”.
ECM Removal and Installation
S6RW0CA106007
For removal and installation, refer to “Engine Control
Module (ECM) Removal and Installation in Section 1C”.
Specifications
Tightening Torque Specifications
S6RW0CA107001
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fasteners Information in Section 0A”.
“a”
3
2
1
I7RW01A10007-01
I5JB0AA10009-01
Fastening part
Tightening torque
Note
N
⋅
m kgf-m lb-ft
CPP switch lock nut 7.5 0.75 5.5 )